你所需要的
-
-
Remove 2 screws first
-
Lift the cover
-
Disconnect LCD FPC
-
Then remove 4 screws
-
Remove LCD assembly
-
-
-
-
Remove 1 screw under the DC power cable notch cover
-
-
-
Remove 4 screws and be ware the length difference
-
Peel the rubber open from right hand side
-
Remove 1 screw
-
-
-
Now the back case can be removed.
-
There's no fragile FPC or cables in this step. Just be patient.
-
-
-
Use 10kohm, >2W resistor, connect Brown and Blue point for more than 10sec.
-
12条评论
Hi Terrance - the return spring on the on/off switch has gone on mine - are you able to see how to get at this on your stripped down one?
freecycle at evendine dot eclipse dot co dot uk in case I don’t notice it coming up here
hmm, haven’t dug that deep yet… The front case disassembly seems very tricky. Also the IR-cut removal.
Terrance -
Sorry to hear that, I arrive here coming for a solution for the return spring on the on/off switch, is not a big problem but a pain and battery drain if you don’t realise :)
Anyway thanks for your teardown really formative.
I tried to remove the top cover to repair the return spring on the ON/OFF, but I was not able to separate it from the body. I have no solution.
I finally got my hands on a wasted 1J5 and go on with the tear down. FYI top cover is sort of easy to remove, but very tricky. post more photos later.
I some simple words, after removing main PCB, remove some screws from left-upper right-upper and inside flash bay,you can wiggle the top clean off.
And, the power switch is berried very deep. you have to fond all sneaky screws. Aaaaaand the mode dial cap is double-side-taped, some thermal energy needed.
Terrance -