Skip to main content

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的指南

英语
中文

正翻译步骤 11

Step 11
For the last section, battery leads will be soldered to surface-mount solder pads. These type of joints are harder to solder because the lead has no solid anchor point (such as a thru-hole) to hold it in place during soldering.
Advanced Guide
  • For the last section, battery leads will be soldered to surface-mount solder pads. These type of joints are harder to solder because the lead has no solid anchor point (such as a thru-hole) to hold it in place during soldering.

  • To de-solder the joint, place a solder wick on top of the existing solder ball and press down on the solder wick with the soldering iron.

  • Once the solder melts and flows into the wick, remove the wick from the joint.

  • Repeat the same procedure on the remaining leads.

  • When a section of solder wick is saturated with solder, it should be trimmed and discarded.

对于最后一部分,电池引线将焊接到表面贴装焊盘。 这些类型的接头难以焊接,因为引线在焊接过程中没有固定的锚定点(例如通孔)将其固定到位。

要焊接接头,将吸锡线放在现有焊球的顶部,然后用烙铁将吸锡线向下压。

一旦焊料熔化并流入吸锡线,从接头上取下吸锡线。

对剩余的引线重复相同的步骤。

当一段吸锡线被焊料充满后,应对其进行修整和丢弃。

在开源创作共享许可协议下,你的投稿已被许可