修复你的物品 社区 商店

iPhone 7 电池更换

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的指南。

返回指南
英语
中文
上一步 下一步

正翻译步骤 5

步骤 5
iPhone 7 Battery Replacement, Methods to unstick the battery from the case: 步骤 0 中的图像 1，3 iPhone 7 Battery Replacement, Methods to unstick the battery from the case: 步骤 0 中的图像 2，3 iPhone 7 Battery Replacement, Methods to unstick the battery from the case: 步骤 0 中的图像 3，3
Methods to unstick the battery from the case

  • If any of the adhesive strips broke off and the battery remains stuck to the rear case, remove it by adding a few drops of isopropyl alcohol (90% or greater) underneath the battery near the stuck strip(s).

  • After about a minute, gently lift the battery.

  • Do not insert your spudger in the area between the volume down (-) button and the top edge of the battery, or you may damage the volume control cable lying underneath.

  • Do not pry against the logic board or you may damage the phone.

  • Don't try to forcefully lever the battery out. If needed, apply a few more drops of alcohol to further weaken the adhesive. Never deform or puncture the battery with your pry tool.

  • If the battery remains stuck to the rear case, prepare an iOpener or use a hair dryer to heat the rear case directly behind the battery. It should be slightly too warm to touch comfortably.

  • Overheating the iPhone may ignite the battery.

  • A piece of dental floss may be used to separate the battery from the rear case. A stronger alternative to dental floss is an unwound guitar string, such as a 0.009 E string from a 12-string set. Thread the floss or string behind the upper battery corners, bring the ends together, wrap them around a folded cloth, and pull evenly.

移除电池的方法……

如果有任何胶条断裂，但电池仍然粘在后壳上，请在电池下面靠近被粘住的地方滴几滴异丙醇（90%或更高），将其清除。

大约一分钟后，轻轻地抬起电池。

不要把你的撬棒插入音量降低（-）按钮和电池顶部边缘之间的区域，否则你可能会损坏下面的音量控制线。

不要撬动主板，否则可能损坏手机。

不要试图强行撬出电池。如果需要，再滴上几滴酒精，以进一步降低粘合剂的粘性。千万不要使用你的工具使电池变形或刺破。

如果电池仍然粘在后壳上，请准备一个iOpener或者使用吹风机来直接加热后壳的外部， 记得用温热的档位加热，保持在你可以舒服触摸的温度就好。

iPhone过热可能会引燃电池。

牙线可以用来将电池与后壳分开。比牙线更结实的替代物可以是吉他弦，比如09 规格的 HIGH E 弦。将牙线或琴弦穿到电池的一角下，拉紧后做好手部防护，然后均匀地拉动。

您的所有投稿皆享有基于开源创作共享许可协议（CC BY-NC-SA）的著作权利。