跳转到主内容

iPhone 6 plus 电池更换

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的5指南

英语
中文

正翻译步骤 2

步骤 2
iPhone 6 Plus Battery Replacement: 步骤 0 中的图像 1,2 iPhone 6 Plus Battery Replacement: 步骤 0 中的图像 2,2
  • Try to keep the strips flat and unwrinkled during this procedure; wrinkled strips will stick together and break instead of pulling out cleanly.

  • Very slowly, pull and stretch one adhesive strip away from the battery, toward the bottom of the iPhone.

  • Allow the strip to stretch out before pulling any harder. If you can't feel it stretching, ease up, or it will break.

  • Pull at as low of an angle as you can without snagging the adhesive strip on any of the components along the lower edge of the phone.

  • Don't press down on the battery as you pull the strip.

  • The strip will stretch to many times its original length. Continue pulling slowly until it releases and slips out from underneath the battery.

  • If the battery adhesive tabs break during the removal process, use your fingers or blunt tweezers to retrieve the remaining length of adhesive, and continue pulling.

  • If any of the adhesive strips break underneath the battery and cannot be retrieved, try to remove the remaining strips, and then proceed as instructed below.

在进行此步骤时,请尽量保持胶带平整。不平整的胶带可能会粘在一起或者断裂而导致不能完整取出

请缓慢地将胶带由电池向iPhone底部方向拉出

在用力拉之前,请让胶带伸展开来。如果你在拉的时候感觉不到它在伸展,请放松一点,否则胶带会断裂。

以尽可能低的角度拉出胶条,在拉出胶条过程中不要碰到手机上的任何配件。

在拉出胶带的时候,请不要按压电池

胶带可能会被拉伸至数倍于电池的长度。在它完全被从电池下方拉出来前请继续拉。

如果胶条在拉出来的过程中断裂,请将剩余部分卷在手指或者钝镊子上继续拉

如果任何胶条在电池下方断开,无法取出,请尝试取出剩余的胶带,然后按以下步骤处理

您的所有投稿皆享有基于开源创作共享许可协议(CC BY-NC-SA)著作权利