修复你的物品 社区 商店

iPad Mini CDMA 前面板组件更换

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的5指南。

返回指南
英语
中文
上一步 下一步

正翻译步骤 2

步骤 2
iPad Mini CDMA Front Panel Assembly Replacement, Front panel preparation: 步骤 0 中的图像 1，2 iPad Mini CDMA Front Panel Assembly Replacement, Front panel preparation: 步骤 0 中的图像 2，2
Front panel preparation

  • This is a good time to power on your iPad and test all functions before you seal the display in place. Be sure to power your iPad back down completely before you continue.

  • If you're installing a new front panel assembly, it may need the following preparation:

  • Peel the large clear plastic liner off of the inside of the glass.

  • Peel any blue plastic backings covering the adhesive around the perimeter of the front panel assembly.

  • Once removed, the adhesive strips will be exposed. Don't remove these backings until you're ready to install the front panel assembly.

  • Don't remove any copper coverings from the outlined region, such as yellow kapton tape or black electrical tape.

  • Ensure the glass panel is free of fingerprints and grime before installing it on your device.

在此插入翻译

如果您要安装新的面板组件，那您需要做些准备。

剥离围绕前面板组件周边的粘合剂的塑料条。

从数字转换器电缆上取下小块粘合剂。

确保所有的铜焊覆盖在新的更换屏幕上，一旦 错误安装，屏幕将随意移动。

-[* icon_note] If you're installing a new front panel assembly, it may need the following preparation:
- [* red] Peel the plastic strips covering the adhesive around the perimeter of the front panel assembly.
- [* orange] Remove the small piece of adhesive backing from the digitizer cable.
-[* black] Make sure all copper is covered on the new replacement screen as once fitted without this the screen will move randomly.
+[title] Front panel preparation
+[* icon_reminder] This is a good time to power on your iPad and test all functions before you seal the display in place. Be sure to power your iPad back down completely before you continue.
+[* icon_note] If you're installing a new front panel assembly, it ***may*** need the following preparation:
+ [* red] Peel the large clear plastic liner off of the inside of the glass.
+ [* orange] Peel any blue plastic backings covering the adhesive around the perimeter of the front panel assembly.
+ [* icon_caution] Once removed, the adhesive strips will be exposed. Don't remove these backings until you're ready to install the front panel assembly.
+ [* yellow] ***Don't remove any copper coverings from the outlined region***, such as yellow kapton tape or black electrical tape.
+[* black] Ensure the glass panel is free of fingerprints and grime before installing it on your device.

您的所有投稿皆享有基于开源创作共享许可协议（CC BY-NC-SA）的著作权利。