跳转到主内容

Remplacement de la plaque de protection de la Nintendo Switch

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的20指南

英语
法语

正翻译步骤 3

步骤 3
Nintendo Switch Shield Plate Replacement: 步骤 0 中的图像 1,3 Nintendo Switch Shield Plate Replacement: 步骤 0 中的图像 2,3 Nintendo Switch Shield Plate Replacement: 步骤 0 中的图像 3,3
  • Insert a spudger underneath the shield plate along the edge of the device.

  • Pry up to lift the shield plate and remove it from the device.

  • You may feel a bit of resistance. This is normal, since the shield plate is slightly bonded to the heat sink with thermal paste.

  • A thick pink thermal compound bridges the gap between the shield plate and the copper heat sink underneath. This helps prevent the Switch from overheating.

  • You can reuse the pink thermal compound if you're careful. Keep the compound clean and make sure it makes solid contact between the heat sink and the shield during reassembly.

  • If you need to replace it, refer to our thermal paste guide to remove the old thermal compound and replace it with an appropriate compound, such as K5 Pro, during reassembly.

Insérez une spatule (spudger) sous la plaque de protection, le long du bord de l'appareil.

Soulevez la plaque de protection et ôtez-la de la console.

Vous pouvez ressentir un peu de résistance. Ceci est normal, car la plaque de protection est légèrement collée au dissipateur thermique avec de la pâte thermique.

De la pâte thermique épaisse rose comble l'espace entre la plaque de protection et le dissipateur thermique en cuivre en dessous. Cela aide à prévenir la surchauffe de la Switch.

Vous pouvez réutiliser la pâte thermique rose si vous êtes prudent. Gardez la pâte propre et assurez-vous qu'elle fasse un bon contact entre le dissipateur thermique et la plaque durant le remontage.

Si vous devez la remplacer durant le remontage, consultez notre tutoriel de pâte thermique pour retirer l'ancienne couche de pâte thermique et la remplacer avec une pâte appropriée, comme la K5 Pro.

您的所有投稿皆享有基于开源创作共享许可协议(CC BY-NC-SA)著作权利