跳转到主内容

三星 Galaxy S7 后盖玻璃更换

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的5指南

英语
中文

正翻译步骤 2

步骤 2
Samsung Galaxy S7 Rear Glass Replacement: 步骤 0 中的图像 1,3 Samsung Galaxy S7 Rear Glass Replacement: 步骤 0 中的图像 2,3 Samsung Galaxy S7 Rear Glass Replacement: 步骤 0 中的图像 3,3
  • When the back panel is warm to the touch, apply a suction cup as close to the heated edge of the phone as you can while avoiding the curved edge.

  • The suction cup will not make a good seal on the curved portion of the glass.

  • If the phone's back cover is cracked, the suction cup may not stick. Try lifting it with strong tape, or superglue the suction cup in place and allow it to cure so you can proceed.

  • Lift on the suction cup and insert an opening pick under the rear glass.

  • The rear glass can break if you use too much force or attempt to pry with metal tools.

  • Due to the curved glass, you will be pushing up, rather than inserting parallel to the plane of the phone.

  • If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools very fast, so you may need to heat it repeatedly.

  • Optionally, once the pick is inserted, you can add a few drops of isopropyl alcohol into the gap to help weaken the adhesive in the following steps.

当玻璃后盖没那么烫的时候,尽可能靠近手机被加热的边缘使用吸盘,同时避开曲面玻璃边缘。

吸盘在玻璃后盖的曲面部位密封性并不好。

如果手机的玻璃后盖已经碎掉了,吸盘可能不能吸起后盖。尝试使用强力胶带移除破碎的后盖,或者将吸盘加盖到适当位置并使其固定,以便继续操作。

往上提起吸盘,然后往玻璃后盖和中框的缝隙中插入撬片。

如果你使用太大的力气或者尝试使用金属工具,玻璃后盖可能会破碎。

由于后盖玻璃是曲面玻璃,您需要将撬片往上推而不是平行插入手机中。

如果你遇到了问题,继续加热手机以软化胶水,然后再次尝试。胶水冷却得非常快,所以你可能需要重复加热多次。

另外,当你插入撬片后,你可以往缝隙中滴入几滴异丙醇以助于在后续步骤中软化胶水。

您的所有投稿皆享有基于开源创作共享许可协议(CC BY-NC-SA)著作权利