iHome IBT16 Micro USB port Replacement - iFixit 维修指南

加入维修社区 - 创建账户

简介

After reading this guide you will know how to replace the micro USB port on an iHomeiBT16.

你所需要的

1. 步骤 1 Base Plate
  Make sure to flip the device over to get into the correct orientation
  
  Using the Philips #00 Screwdriver, unscrew and remove the four 9mm black screws on the base plate of the device.
  
  Make sure to keep these screws in a safe location so you don't lose them
  翻译
  
  询问修复机器人
  
  添加评论
  
  1024
2. 步骤 2
  Using the plastic opening tool, insert into the crack between the base plate and the main body of the device
  
  Using a lever like motion, push the opening tool down thus lifting the plate
  
  You will need to use your fingers to lift the base plate off the main body of the device
  
  The motherboard is directly underneath the base plate
  翻译
  
  询问修复机器人
  
  添加评论
  
  1024
1. 步骤 3 Micro USB port
  Inside the iHome remove the two silver Phillips screws that are on the motherboard.
  
  Connect the ground strap to ground, and then put the strap around your wrist.
  翻译
  
  询问修复机器人
  
  添加评论
  
  1024
2. 步骤 4
  Take the motherboard out of the device, use the plastic opening tool to ensure the power switch doesn't get stuck.
  翻译
  
  询问修复机器人
  
  添加评论
  
  1024
3. 步骤 5
  On the other side of the motherboard unsolder the two biggest solder joints under the micro USB.
  翻译
  
  询问修复机器人
  
  添加评论
  
  1024
4. 步骤 6
  On the side of the motherboard that the micro USB connector is there are five surface mount solder joints at the back of the connector. Unsolder these five solder joints.
  翻译
  
  询问修复机器人
  
  添加评论
  
  1024

结论

To reassemble your device, follow these instructions in reverse order.

取消：我没有完成这个指南。

作者

与3其他贡献者

Steven Ferreira

于03/08/17注册

222 声望

创作了2篇指南

+ 2更多徽章

团队

UMass Dartmouth, Team S3-G6, Botvin Spring 2017 UMass Dartmouth, Team S3-G6, Botvin Spring 2017 的会员

UMASSD-BOTVIN-S17S3G6

2 名成员

创作了10篇指南

0指南评论

浏览统计数据:

过去 24 小时： 1

过去 7 天： 6

过去 30 天： 21

总计 1,729