跳转到主内容

简介

Use this guide to remove the glass in the scanner bed in order to replace it.

配件

没有特定配件。

  1. On the bottom of the scanner, remove the screw at the top left side.
    • On the bottom of the scanner, remove the screw at the top left side.

  2. Remove the rubber foot pad opposite the screw hole to expose a second screw hole. Remove the screw beneath the foot-pad.
    • Remove the rubber foot pad opposite the screw hole to expose a second screw hole.

    • Remove the screw beneath the foot-pad.

  3. iPhone X Fix Kits

    Warranty up? No worries, we’ve got the fix.

    现在开始购物

    iPhone X Fix Kits

    Warranty up? No worries, we’ve got the fix.

    现在开始购物
  4. Rotate the scanner so the screw hole is located on the top left hand side. Place the plastic opening tool between the top casement and bottom casement of scanner with the hook facing up. Gently pry the two casements apart beginning above the screw hole and working your way around.
    • Rotate the scanner so the screw hole is located on the top left hand side.

    • Place the plastic opening tool between the top casement and bottom casement of scanner with the hook facing up.

    • Gently pry the two casements apart beginning above the screw hole and working your way around.

    • Note that the top and bottom casings are held together by a series of 6 tabs. There is one tab on each of the long sides of the scanner approximately 6 inches in from the corners. There are two tabs on each of the short sides of the scanner approximately 2.3 inches in from the corners. Use the spudger to unhook the tab from the top casement.

  5. Separate the two casement pieces.
    • Separate the two casement pieces.

  6. Apply even pressure against the back of the glass while securing the plastic frame in place.
    • Apply even pressure against the back of the glass while securing the plastic frame in place.

  7. With consistent pressure on the glass, move your fingers down the sides until the glass is no longer stuck to the double-sided tape. With consistent pressure on the glass, move your fingers down the sides until the glass is no longer stuck to the double-sided tape.
    • With consistent pressure on the glass, move your fingers down the sides until the glass is no longer stuck to the double-sided tape.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Jena

于2013年10月18日注册

608 信誉积分

创作了6篇指南

团队

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 158