简介

This will show how to change a broken display. The display is readily available at many different sources and should cost no more than $15. The repair is quick and does not require any special skills, like soldering etc.

  1. Here is my Samsung S630. Nice little camera with just one flaw. The LCD display was broken.
    • Here is my Samsung S630. Nice little camera with just one flaw. The LCD display was broken.

  2. Remove the two screws on the left side. Remove the two on the right side. Remove the four screws on the bottom. All eight screws are the same, so no need to ensure proper position when reassembling.
    • Remove the two screws on the left side.

    • Remove the two on the right side.

    • Remove the four screws on the bottom. All eight screws are the same, so no need to ensure proper position when reassembling.

  3. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  4. Open the battery cover and split the housing carefully. Start at the battery compartment and work your way around it. You can use an opening tool or your fingernails. Also make sure to open the USB port cover.
    • Open the battery cover and split the housing carefully. Start at the battery compartment and work your way around it. You can use an opening tool or your fingernails. Also make sure to open the USB port cover.

  5. You now look directly onto the LCD. Gently move the LCD out of the frame and fold it toward the bottom of the camera. Do not try to remove it. It is still attached. Remove the four screws that hold the frame to the logic board.
    • You now look directly onto the LCD.

    • Gently move the LCD out of the frame and fold it toward the bottom of the camera. Do not try to remove it. It is still attached.

    • Remove the four screws that hold the frame to the logic board.

  6. This particular camera has some Kapton tape holding the cable to the logic board. Gently remove it from the board only. Open the locking tab on the PCB connector and remove the cable. This will separate the LCD from the board.
    • This particular camera has some Kapton tape holding the cable to the logic board. Gently remove it from the board only.

    • Open the locking tab on the PCB connector and remove the cable. This will separate the LCD from the board.

    • This is what the logic board looks like without the frame and the LCD.

结论

To reassemble your device, follow these instructions in reverse order.

3等其他人完成本指南。

oldturkey03

于2010年09月29日注册

558,908 信誉积分

创作了101篇指南

团队

OTS OTS 的会员

Business

1 名成员

创作了123篇指南

浏览统计数据:

过去的24小时: 1

过去的7天: 3

过去的30天: 5

总计 2,008