简介

This guide will provide a step-by-step procedure for replacing the motherboard in your Samsung Rogue. The motherboard includes the headphone jack and charge port.

  1. Before disassembling your Samsung Rogue, make sure it is powered off.
    • Before disassembling your Samsung Rogue, make sure it is powered off.

    • With your thumbs, push down on the back cover of your phone and slide it away from the camera.

  2. You can now remove the battery by prying it up with your finger.
    • You can now remove the battery by prying it up with your finger.

    • Use a plastic opening tool to carefully pry the back cover surrounding the camera up from the phone.

    • Remove the five 3.4mm Philips screws securing the backing of the phone.

    • Use a plastic opening tool to carefully pry off the back cover.

    • Make sure you are prying along the edge and not between the two halves of the phone that slide away from each other.

    • Be careful to not drop the volume changing piece, for it can easily slip out.

    • Remove the two 3.45 mm Philips screws below the white sticker.

    • Carefully lift the motherboard up from the bottom edge.

    • The film of wires is still attached to the motherboard, so do not completely remove the motherboard just yet or you may damage it.

    • Use a plastic opening tool to disconnect the film from the motherboard.

    • On the underside of the motherboard, remove the single 3.3mm Philips screw.

    • The speaker and the antenna are both connected on the same black piece.

    • Use a plastic opening tool to pop off the edges of the speaker/antenna piece from the motherboard.

    • Turn over the motherboard and carefully lift the speaker/antenna piece straight up.

    • The camera is held in the middle of the speaker/antenna piece. Make sure to lift directly up when lifting the speaker/antenna piece, otherwise you can risk damaging the camera.

    • With two fingers carefully detach the camera from the motherboard by lifting straight up.

    • Do not pick it up by the camera itself. Handle the little black box it is attached to instead.

    • Use a plastic opening tool to take the silver plate off of the motherboard.

结论

To reassemble your device, follow these instructions in reverse order.

Blaine Nesbit

于2012年04月15日注册

7 信誉积分

撰写一个指南

团队

Cal Poly, Team 7-32, Maness Spring 2012 Cal Poly, Team 7-32, Maness Spring 2012 的会员

CPSU-MANESS-S12S7G32

4 名成员

创作了16篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 544