跳转到主内容

修复你的物品

维修的权力

商店

简介

Use this guide to replace a cracked or broken screen on your Galaxy Watch.

  1. Remove the four Tri-point #00 screws (4.2 mm length) on the backside of the watch.
    • Remove the four Tri-point #00 screws (4.2 mm length) on the backside of the watch.

  2. Use an opening tool to get between the back cover and the metal housing of the watch. Carefully pry the plastic back cover open.
    • Use an opening tool to get between the back cover and the metal housing of the watch.

    • Carefully pry the plastic back cover open.

    • Don't remove the back cover yet. There is a flex cable running to the core assembly inside.

  3. Lay down the watch and lift the back cover to access the sensor connector on the motherboard. Lay down the watch and lift the back cover to access the sensor connector on the motherboard.
    • Lay down the watch and lift the back cover to access the sensor connector on the motherboard.

  4. 打开所有标签

    Mac的RAM升级套装

    购买套装

    所有选项卡都有足够的 RAM

    购买套装
  5. Use a spudger to disconnect the sensor flex cable from the motherboard. Use a spudger to disconnect the sensor flex cable from the motherboard.
    • Use a spudger to disconnect the sensor flex cable from the motherboard.

  6. Remove the back cover. When closing the watch make sure the rubber gasket is undamaged or replace it with a new one. When closing the watch make sure the rubber gasket is undamaged or replace it with a new one.
    • Remove the back cover.

    • When closing the watch make sure the rubber gasket is undamaged or replace it with a new one.

  7. Use a spudger to disconnect the display flex cable from the motherboard. Use a spudger to disconnect the display flex cable from the motherboard.
    • Use a spudger to disconnect the display flex cable from the motherboard.

  8. Lift the core unit out of the housing. The core's plastic frame sits tight inside the housing.
    • Lift the core unit out of the housing.

    • The core's plastic frame sits tight inside the housing.

    • Carefully thread the display flex cable through the gap of the core's plastic frame.

  9. If necessary apply some tape over the display to avoid any injury from glass shards.
    • If necessary apply some tape over the display to avoid any injury from glass shards.

  10. Use your finger or thumb to steadily push down on the display to loosen the adhesive. Heating the display with a hair dryer or iOpener helps softening the adhesive.
    • Use your finger or thumb to steadily push down on the display to loosen the adhesive.

    • Heating the display with a hair dryer or iOpener helps softening the adhesive.

    • Remove the display.

结论

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

另外一个人完成了本指南。

Tobias Isakeit

于2014年03月31日注册

72,221 信誉积分

创作了140篇指南

团队

iFixit iFixit 的会员

Community

129 名成员

创作了12,468篇指南

添加评论

浏览统计数据:

过去的24小时: 31

过去的7天: 153

过去的30天: 323

总计 323