简介

First you take the front apart and then you take the back apart in order to get to the hinge.

  1. push down the back cover of the phone, then take it out.
    • push down the back cover of the phone, then take it out.

    添加评论

  2. Remove the battery.
    • Remove the battery.

    添加评论

    • Remove the two 4 mm screws on screen.

    添加评论

    • Remove front outside casing with plastic opening tools.

    添加评论

    • Remove ribbon connector next to camera using tweezers.

    添加评论

    • Unscrew and remove the two 3.95 mm screws underneath that ribbon connector.

    • Be careful not to lose their accompanying plastic washers.

    添加评论

    • Pull the two halves of the phone apart.

    • The phone will not slide straight apart. You have to angle the back half up a little.

    • Do not force it. Jiggle it a little if it doesn't come apart.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the plastic panel cover from the hinge.

    添加评论

    • Remove the 3.41 mm screw out from underneath plastic cover.

    添加评论

    • Pop out top half of hinge with plastic opening tool. This will release hinge cover for removal.

    添加评论

    • Pull off hinge cover.

    添加评论

    • Remove the two 2.71 mm screws on the hinge using screwdriver.

    • Under these screws will be a washer, spring, and small metal disc. Make sure you don't lose these.

    添加评论

    • Remove Verizon logo from back of phone using plastic opening tool

    • The logo is attached with glue. It will be sticky but it just pulls off.

    添加评论

    • Remove the four 4.44 mm screws from the back.

    • Remove the three 4.35mm screws from under the Verizon logo.

    • Make sure you don't mix the screws together.

    添加评论

    • Pull back off using plastic opening tool

    • Do Not lose the buttons on the side of the phone, as they will come off of the phone when you remove the back outside casing.

    添加评论

    • Pull up on yellow tab.

    添加评论

    • Disconnect connecting cord using tweezers.

    添加评论

    • Disconnect rectangular ribbon.

    添加评论

    • Take out the logic board.

    添加评论

    • Remove the three 3.95 mm screws.

    • The two rightmost screws must be pulled out with tweezers after unscrewed.

    添加评论

    • Pull the hinge out.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Chris

于2011年04月16日注册

133 信誉积分

创作了5篇指南

团队

Cal Poly, Team 12-35, Maness Spring 2011 Cal Poly, Team 12-35, Maness Spring 2011 的会员

CPSU-MANESS-S11S12G35

4 名成员

创作了10篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 2

总计 4,021