简介

This guide will help you remove the back cover of your device. You’ll need a Phillips #000 screwdriver to complete this guide.

  1. Scratch off the right-hand side of the sticker at the center of the bottom case using the spudger until the screw is visible.
    • Scratch off the right-hand side of the sticker at the center of the bottom case using the spudger until the screw is visible.

    • Remove this screw with the Phillips #000 screwdriver.

    添加评论

  2. Remove the two visible screws on the bottom with the Phillips #000 screwdriver.
    • Remove the two visible screws on the bottom with the Phillips #000 screwdriver.

    添加评论

    • Use your fingers to peel off the four corner rubber feet on the bottom.

    • Use the Phillips #000 screwdriver to remove the four screws beneath the rubber feet.

    添加评论

    • Flip the case to its upright position.

    • Place one hand on the bottom plate of the case and one on the top plate. Gently pull apart the two plates by tilting the top plate about the front of the device. Treat the front of the device as a hinge.

    • Remove the back cover from the device.

    • Be sure not to rip the wire connection of the LED bulb that is still connected to the bottom plate.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Viet Nguyen

于2018年04月17日注册

208 信誉积分

创作了2篇指南

团队

Cal Poly, Team S24-G12, Maness Spring 2018 Cal Poly, Team S24-G12, Maness Spring 2018 的会员

CPSU-MANESS-S18S24G12

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 8

总计 71