跳转到主内容

你所需要的

  1. Roku 4 Remote Control Buttons Replacement, Remote Control Motherboard: 步骤 1 中的图像 1,1
    • Place the remote control facing down on the table, so that the buttons are facing downwards.

  2. Roku 4 Remote Control Buttons Replacement: 步骤 2 中的图像 1,2 Roku 4 Remote Control Buttons Replacement: 步骤 2 中的图像 2,2
    • Remove the battery compartment cover from the back of the remote by sliding it outwards. This should reveal the batteries.

  3. Roku 4 Remote Control Buttons Replacement: 步骤 3 中的图像 1,2 Roku 4 Remote Control Buttons Replacement: 步骤 3 中的图像 2,2
    • Remove the batteries from the battery compartment.

  4. Roku 4 Remote Control Buttons Replacement: 步骤 4 中的图像 1,1
    • Turn the Phillips PH0 screwdriver counterclockwise to carefully remove the 6.9 mm screw located between both battery compartments .

  5. Roku 4 Remote Control Buttons Replacement: 步骤 5 中的图像 1,1
    • Wedge a plastic opening tool into the seam between the top cover and bottom casing of the device to create a gap.

    • Prying open the remote is quite difficult and requires a large amount of force. Use caution to avoid breaking the device or hurting yourself.

    • Once you have created a gap large enough for your fingers to fit between, separate the top cover from the bottom plastic casing by pulling them apart gently.

  6. Roku 4 Remote Control Buttons Replacement: 步骤 6 中的图像 1,3 Roku 4 Remote Control Buttons Replacement: 步骤 6 中的图像 2,3 Roku 4 Remote Control Buttons Replacement: 步骤 6 中的图像 3,3
    • Using your right thumb, lift up on the left side of the motherboard to remove it from the bottom plastic casing.

  7. Roku 4 Remote Control Buttons Replacement, Remote Control Buttons: 步骤 7 中的图像 1,1
    • Remove the three plastic sheets from the rubber button panels by gripping one edge of the sheet and pulling upward.

  8. Roku 4 Remote Control Buttons Replacement: 步骤 8 中的图像 1,3 Roku 4 Remote Control Buttons Replacement: 步骤 8 中的图像 2,3 Roku 4 Remote Control Buttons Replacement: 步骤 8 中的图像 3,3
    • Remove the button panels by gripping the bottom edge and pulling upward until the panel is no longer in contact with the remote cover.

结论

To reassemble your device, follow these instructions in reverse order.

8等其他人完成本指南。

Hank Harrison

于2017年03月26日注册

431 声望

创作了3篇指南

团队

Baylor, Team S5-G4, Williams Spring 2017 Baylor, Team S5-G4, Williams Spring 2017 的会员

BU-WILLIAMS-S17S5G4

3 名成员

创作了4篇指南

一条评论

If you had the idea to just put some tape over the contacts for buttons you want to disable, don't bother. The buttons are not typical conductive rubber keypads; they actually depress physical dome switches, and that membrane is glued to the PCB. It appears that defeating the switches requires permanent modification, either to the rubber keypad or to the switch itself.

Bitt Faulk - 回复

添加评论

浏览统计数据:

过去 24 小时: 12

过去 7 天: 133

过去 30 天: 567

总计 16,395