简介

This is a guide on how to replace the touch screen on a Palm Tungsten E.

  1. Remove stylus and SD card. Using T-5 torx driver, remove 4 back panel screws.
    • Remove stylus and SD card.

    • Using T-5 torx driver, remove 4 back panel screws.

    • The screws are small and can be lost easily. Be sure to place them in a secure area.

  2. Begin to remove back cover by inserting the plastic opening tool under the usb and power input slots. Continue by sliding the plastic opener to the right at the markers shown until the cover releases. Continue by sliding the plastic opener to the right at the markers shown until the cover releases.
    • Begin to remove back cover by inserting the plastic opening tool under the usb and power input slots.

    • Continue by sliding the plastic opener to the right at the markers shown until the cover releases.

  3. Your device may not have a screen protector. If not, you do not need to complete step three. Please move on to step four. Remove screen protector by lifting hinge out of plastic housing.
    • Your device may not have a screen protector. If not, you do not need to complete step three. Please move on to step four.

    • Remove screen protector by lifting hinge out of plastic housing.

    • Remove top cover by gently pulling away from the device with plastic tool

  4. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  5. Carefully remove motherboard from the standoffs without damaging the LCD flex connector. Using spudger( the black pencil-like tool shown in picture two), unlock both sides of the flex connector block (shown in the purple boxes in picture two) by pushing down.
    • Carefully remove motherboard from the standoffs without damaging the LCD flex connector.

    • Using spudger( the black pencil-like tool shown in picture two), unlock both sides of the flex connector block (shown in the purple boxes in picture two) by pushing down.

    • Remove motherboard completely.

    • Metal washers may pop out of the device during this step

  6. Remove buttons using fingers. Gently flex frame to release screen from plastic frame. Lift out screen.
    • Remove buttons using fingers.

    • Gently flex frame to release screen from plastic frame.

    • Lift out screen.

  7. Congratulations! You have successfully taken apart a Palm Tungsten E.
    • Congratulations! You have successfully taken apart a Palm Tungsten E.

  8. Reassemble the device in the reverse order of the tear down using the new screen in place of the old screen.
    • Reassemble the device in the reverse order of the tear down using the new screen in place of the old screen.

    • To reconnect the flex connector press up on the blocks with the spudger to ensure they click into place.

    • Be careful not to damage the flex connector.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Kevin Hom

于2010年01月21日注册

88 信誉积分

创作了2篇指南

团队

Cal Poly, Team 13-22, Maness Winter 2010 Cal Poly, Team 13-22, Maness Winter 2010 的会员

CPSU-MANESS-W10S13G22

4 名成员

创作了4篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 3

总计 5,096