加入维修社区 - 创建账户

简介

This guide shows how to replace the A, B, X, and Y action buttons in a Razer Wolverine V3 Pro Wireless Controller. If the buttons are damaged, unresponsive, or worn out, replacement may be necessary. You can also use this guide to install custom buttons if desired.

Important Safety Information:

Disconnect the controller from the charger, console, or PC before you begin to avoid electrical damage.

你所需要的

步骤 1 Outer Shell

Razer Wolverine V3 Pro Action Buttons Replacement, Outer Shell: 步骤 1 中的图像 1，3

Razer Wolverine V3 Pro Action Buttons Replacement, Outer Shell: 步骤 1 中的图像 2，3

Razer Wolverine V3 Pro Action Buttons Replacement, Outer Shell: 步骤 1 中的图像 3，3

Insert the end of a spudger or opening tool in the seam at the top of the controller.
Slide it around the edge to release the retaining clips.
Use the spudger to separate the front and back plastic outer shell of the controller.
Both panels should separate from the front of the bumpers.
This takes some patience to ensure the panels don’t crack.
Flip the controller so the bottom is facing up.
Use the spudger to separate the plastic covering on the hand grips.

翻译

询问修复机器人

步骤 2

Use a JIS #0 screwdriver to remove ten 10 mm screws from the mid-frame.
Keep screws organized.

翻译

询问修复机器人

步骤 3

Use your hands to pry the back panel of the controller.
You now have access to the back buttons (2 on each side).

翻译

询问修复机器人

步骤 4

Remove the two JIS #0 scews securing the battery.

翻译

询问修复机器人

步骤 5

Lift the actuators out of the way to access the screws beneath.
Use a Phillips #0 screwdriver to remove the two 6.9 mm screws under the voice coil actuators.

翻译

询问修复机器人

步骤 6

Remove the face cover from the controller.
The buttons may fall out in the process of removing the face cover. Be careful to not to lose them.
Now you have access to the internal components of the controller.