简介

Use this guide to remove the right function board from the front panel of the DVD player.

配件

无需配件。

Eject the disk tray from the DVD player before removing power supply.
  • Eject the disk tray from the DVD player before removing power supply.

添加评论

Evenly lift upward on the disk tray front cover (not slanted, as pictured). This will allow for easier dissasembly of the player.
  • Evenly lift upward on the disk tray front cover (not slanted, as pictured). This will allow for easier dissasembly of the player.

添加评论

Remove 3 screws running along back edge of case cover. Remove 2 screws from each side of case cover.
  • Remove 3 screws running along back edge of case cover.

  • Remove 2 screws from each side of case cover.

添加评论

Mac RAM 套件
加速你的Mac。充分利用它的内存。
Mac RAM 套件
从Mac中清理出更多内存。
Grab edges of cover, pull outward slightly, and pull straight up.
  • Grab edges of cover, pull outward slightly, and pull straight up.

添加评论

Lift up the 5 tabs securing the front panel to the chassis. There are 3 on the bottom, and 2 on the inside edges of the panel. Panel should then lift off the player. Lift up the 5 tabs securing the front panel to the chassis. There are 3 on the bottom, and 2 on the inside edges of the panel. Panel should then lift off the player.
  • Lift up the 5 tabs securing the front panel to the chassis. There are 3 on the bottom, and 2 on the inside edges of the panel. Panel should then lift off the player.

添加评论

Remove 4 screws as shown.
  • Remove 4 screws as shown.

添加评论

Push in plastic retainer tab on board. Grasp edges of board and pull out. Grasp edges of board and pull out.
  • Push in plastic retainer tab on board.

  • Grasp edges of board and pull out.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Kevin

于2011年04月26日注册

351 信誉积分

创作了8篇指南

团队

Cal Poly, Team 18-20, Garner Spring 2011 Cal Poly, Team 18-20, Garner Spring 2011 的会员

CPSU-GARNER-S11S18G20

4 名成员

创作了11篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 1,873