简介

This guide will help you take apart, clean, and (if necessary) replace the palm treo keyboard.

Position the phone so the screen faces down.
  • Position the phone so the screen faces down.

  • Remove the stylus found on the back of the phone.

添加评论

To remove the battery cover, hold down the button in the middle of the phone's back.
  • To remove the battery cover, hold down the button in the middle of the phone's back.

  • Slide the cover down to remove. Set the cover aside.

添加评论

  • Lift the edge of the battery, separating contact points, and pull out as pictured.

添加评论

  • Remove the small round rubber cover on the back of the phone located immediately below the antenna.

  • This will uncover a screw that will be removed in the next step.

添加评论

  • Unscrew six black 6.9 mm Torx screws with a T5 Torx Screwdriver.

  • Unscrew one 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver.

  • Pull out antenna.

添加评论

  • Pry the back cover off using a spudger or similar tool.

  • The back cover is attached by several small clips on the inside.

添加评论

  • Unclip the gray tab.

  • Pull out the orange ribbon cable.

  • Do not remove the motherboard before disconnecting the ribbon cable--Damage may occur!

添加评论

  • Pull off the mother board.

  • Install replacement or repaired motherboard, reversing steps above.

添加评论

  • Unscrew the two 3.2 mm screws with a Phillips #00 screwdriver.

添加评论

  • Pull off the circuit board.

添加评论

  • Remove the keypad for cleaning or replacing.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

cgood

于2009年10月28日注册

116 信誉积分

创作了7篇指南

团队

Cal Poly, Team 19-3, Maness Fall 2009 Cal Poly, Team 19-3, Maness Fall 2009 的会员

CPSU-MANESS-F09S19G3

4 名成员

创作了18篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 4

总计 4,509