跳转到主内容

简介

Removing the back case from the speaker is relatively easy. Once you unscrew the four back screws, there is a wire that is attached to the back case. Before pulling the back case completely off, disconnect the wire from the back case by carefully pulling it out with tweezers. This will allow the back case to be completely removed from the device.

  1. Flip the device over so the front of the speaker is facing down. Make sure to place the speaker on a flat surface
    • Flip the device over so the front of the speaker is facing down. Make sure to place the speaker on a flat surface

  2. Use a T6 Torx screwdriver to remove the four 9mm screws from the back of the device. Use a T6 Torx screwdriver to remove the four 9mm screws from the back of the device.
    • Use a T6 Torx screwdriver to remove the four 9mm screws from the back of the device.

  3. Use a magnet to remove the screws after unscrewing them and place them aside. Use a magnet to remove the screws after unscrewing them and place them aside.
    • Use a magnet to remove the screws after unscrewing them and place them aside.

  4. Carefully remove the back cover without breaking the battery wire.
    • Carefully remove the back cover without breaking the battery wire.

  5. Remove the end of the battery connection from the motherboard by holding the end of the wire and carefully pulling it out of the socket using tweezers. The battery is still attached to the back cover.
    • Remove the end of the battery connection from the motherboard by holding the end of the wire and carefully pulling it out of the socket using tweezers.

    • The battery is still attached to the back cover.

结论

To reassemble your device, follow these instructions in reverse order.

3等其他人完成本指南。

[deleted]

于2016年02月17日注册

679 信誉积分

创作了4篇指南

添加评论

浏览统计数据:

过去的24小时: 2

过去的7天: 2

过去的30天: 3

总计 691