简介

Replacing a faulty keypad.

Turn off the phone.
  • Turn off the phone.

  • Check if there is a microSD card in the slot behind the door on the side. If so, remove it by first pushing it in, then pulling it out.

  • Position the phone so that the back side is in view.

添加评论

Remove the back battery cover.
  • Remove the back battery cover.

    • Apply pressure on the cover while simultaneously sliding the cover downward.

添加评论

  • Insert the iPod opening tool between the base of the phone and the phone battery.

  • Position the phone so that the battery won't fall out of the phone.

    • The battery lifts out of the phone fast and easily.

  • Carefully lift the battery out of the phone.

添加评论

  • Turn the phone so that the back of the phone is facing forward.

  • The picture to the left shows the location of the plastic tabs that attach to the upper cover of the phone.

    • In this picture, the upper cover has already been removed.

添加评论

  • Place the iPod opening tool under the tabs near the top of the phone.

  • Slide the iPod Opening Tool upwards.

    • This will pop the tabs and release the upper part of the phone.

  • Repeat for the left and the right sides.

添加评论

  • Place the iPod opening tool at the top area of the bottom section of the phone (indicated in picture).

  • Lift the iPod opening tool to pop open the clips.

    • This will release the upper back cover of the phone.

  • Repeat for the left and the right sides.

添加评论

  • Push upward on the top back cover using two thumbs.

    • This will remove the top back cover from the phone.

添加评论

  • Locate the four screws.

  • Remove the screws using a T6 Torx screwdriver.

添加评论

  • Turn the phone over.

  • Gently pull apart the phone.

    • Start at the bottom of the phone and pull outward.

    • There are plastic catches on the middle of each side. These should pop free as you pull.

    • Be careful, the phone will separate into two sections.

添加评论

  • The phone should now be in two different sections.

    • 1) The logic board and the back cover

    • 2) The keypad and the rest of the phone

添加评论

  • Place the keypad in view.

添加评论

  • Remove the keypad from the phone by lifting the keypad off the phone.

添加评论

  • The keypad should be detached.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Caitlin Rahm

于2010年04月15日注册

78 信誉积分

创作了4篇指南

团队

Cal Poly, Team 26-30, Regan Spring 2010 Cal Poly, Team 26-30, Regan Spring 2010 的会员

CPSU-REGAN-S10S26G30

4 名成员

创作了17篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 1,049