简介

Introduction

This guide shows how to remove and replace the antenna of the Nokia 2630b after full disassembly of the phone.

  1. Press the release buttons located on either side of the battery cover
    • Press the release buttons located on either side of the battery cover

    • Pull the battery cover away from the phone

    添加评论

  2. Gently pull the battery out of the phone with your fingers
    • Gently pull the battery out of the phone with your fingers

    添加评论

    • Remove the two screws on either side of the battery case using the microscrewdriver using the T5 bit

      • The T5 bit has a star shaped end and has "T5" engraved on the side of the bit for easy identification

    • NOTE: Keep the screws in a safe place while you continue working.

    添加评论

    • Separate the front case from the back case using the iPod opener

    • NOTE: The keypad is a loose piece and may fall out

    添加评论

    • Remove screws using the same T5 screw bit to release the computer chip from the case

    • NOTE: Keep the screws in a safe place while you continue working

    添加评论

    • Carefully lift the black frame off the screen with your fingers

    添加评论

    • Carefully remove the computer chip and screen out of the black case with your fingers

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • The screen is attached to the motherboard by an orange ribbon

    • Carefully detach the ribbon from the motherboard using your fingers

    添加评论

    • Reattach new screen by connecting the orange ribbon to the computer chip

    添加评论

    • Place computer chip and screen back into black case

    添加评论

    • Place black frame back over screen

    添加评论

    • Carefully place keypad back in place

    添加评论

    • Snap the front case back in place with the bottom case with your fingers

    添加评论

    • Reassemble screws with microscrewdriver

    添加评论

    • Slide battery back into place

    添加评论

    • Snap battery cover back into place

    添加评论

    • Locate the four screws that secure the back case to the rest of the phone.

    • Unscrew all four screws using a "T-5" star shaped screw driver, turning counter-clockwise.

    添加评论

    • DO NOT PULL APART! There is a wire attaching the speaker to the rear case. It is very important to NOT sever this connection. Because of this, the rear case does not completely detach from the rest of the phone.

    • Holding the rear case, applying pressure to the back of the phone near the location of the battery in order to separate the two components.

    添加评论

    • The antenna is the "L" shaped device located on the top of the phone in between the back case and the board.

    • You should be able to remove the antenna with minimal effort.

    • To put in a new antenna, place it in the same location as the old one. There is no need to connect to any hardware on the phone.

    添加评论

    • To reassemble the device, follow the instructions in reverse order.

    • When reinstalling the keyboard, make sure it is in the correct position before screwing the case back together.

    • When reinstalling the battery, make sure the contacts of the battery connect to the contacts on the phone.

      • The red square in the photo indicates the position of the brass contacts of the battery.

      • The photo displays the correct orientation of the battery.

    添加评论

终点

Eric

于2011年04月07日注册

51 信誉积分

创作了4篇指南

团队

Cal Poly, Team 9-61, Walters Spring 2011 Cal Poly, Team 9-61, Walters Spring 2011 的会员

CPSU-WALTERS-S11S9G61

5 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 2,854