跳转到主内容

修复你的物品

维修的权力

配件 & 工具

简介

This guide will help you remove the front panel of the controller. It is a prerequisite guide only.

配件

没有特定配件。

  1. Pull down on the battery cover release lever and pull back to remove the cover. Pull down on the battery cover release lever and pull back to remove the cover.
    • Pull down on the battery cover release lever and pull back to remove the cover.

  2. Take out each battery then put the covering back on.
    • Take out each battery then put the covering back on.

  3. 任天堂 Switch 套装

    快速恢复到游戏的状态

    购买 Switch 套装

    任天堂 Switch 套装

    快速恢复到游戏的状态

    购买 Switch 套装
  4. Remove the eight 9-mm Tri-Wing screws on the back panel with the Tri-wing Y1 screwdriver. During reassembly, firmly hold the panels of the controller together while replacing screws so the panels don't separate.
    • Remove the eight 9-mm Tri-Wing screws on the back panel with the Tri-wing Y1 screwdriver.

    • During reassembly, firmly hold the panels of the controller together while replacing screws so the panels don't separate.

  5. After each screws has been removed carefully turn over the controller, and place on a flat surface. Slowly separate the top panel from the bottom panel.
    • After each screws has been removed carefully turn over the controller, and place on a flat surface.

    • Slowly separate the top panel from the bottom panel.

    • The buttons are loose and may fall off of the motherboard.

    • Once seperarted set aside the top panel.

    • During reassembly, make sure the front panel lines up with the buttons so they slide back into place.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

JT Gryder

于2013年04月12日注册

63 信誉积分

撰写一个指南

团队

Cal Poly, Team 10-40, Amido Spring 2013 Cal Poly, Team 10-40, Amido Spring 2013 的会员

CPSU-AMIDO-S13S10G40

4 名成员

创作了23篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 6

总计 959