1. Slide the eyepiece up and off the viewfinder. Slide the eyepiece up and off the viewfinder.
    • Slide the eyepiece up and off the viewfinder.

  2. Using a PH000 screwdriver, remove the two 4.8mm Phillips screws from the back of the viewfinder.
    • Using a PH000 screwdriver, remove the two 4.8mm Phillips screws from the back of the viewfinder.

    • Some screws may be JIS. Be wary of this if your PH000 does not feel like it is properly gripping the screws.

  3. Remove the two 6.4mm Phillips screws on the right side of the camera, near the SD card slot.
    • Remove the two 6.4mm Phillips screws on the right side of the camera, near the SD card slot.

  4. Remove the two 6.4mm Phillips screws on the left side of the camera, near the I/O ports.
    • Remove the two 6.4mm Phillips screws on the left side of the camera, near the I/O ports.

  5. 所有超过US$100或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  6. On the bottom of the camera,
    • On the bottom of the camera,

    • remove the two 5.3mm Phillips screws

    • and the other two 6.3mm Phillips screws.

  7. Using a spudger, separate the bottom panel from the rear case just enough to clear the two clips on the rear casing in the next step. Using a spudger, separate the bottom panel from the rear case just enough to clear the two clips on the rear casing in the next step. Using a spudger, separate the bottom panel from the rear case just enough to clear the two clips on the rear casing in the next step.
    • Using a spudger, separate the bottom panel from the rear case just enough to clear the two clips on the rear casing in the next step.

  8. Lift the rear case off of the back of the camera. Don't pull the casing completely off yet, as the ribbon cables are still connected.
    • Lift the rear case off of the back of the camera.

    • Don't pull the casing completely off yet, as the ribbon cables are still connected.

    • Be mindful of the two clips, making sure to keep the bottom panel far enough away to clear them.

  9. Set the rear casing off to the side so you can access the ZIF connectors.
    • Set the rear casing off to the side so you can access the ZIF connectors.

    • The orientation shown in the picture seems to be the best position for the casing to sit comfortably without stressing the ribbon cable connections.

  10. Disconnect the ribbon cables from their respective ZIF connectors on the logic board. Disconnect the ribbon cables from their respective ZIF connectors on the logic board. Disconnect the ribbon cables from their respective ZIF connectors on the logic board.
    • Disconnect the ribbon cables from their respective ZIF connectors on the logic board.

  11. Separate the rear casing from the camera.
    • Separate the rear casing from the camera.

结论

To reassemble your device, follow these instructions in reverse order.

8等其他人完成本指南。

Ryan Lutz

于2011年09月27日注册

2,732 信誉积分

创作了3篇指南

good guidance,easy to follow,thanks

ramalingeswarao kaza - 回复

I want to replace my Nikon D90 DSLR bad LCD, this guide will save me from costly repairs.

ramalingeswarao kaza - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 5

过去的30天: 21

总计 3,064