Nabi Jr Motherboard Replacement

Remove the red rubber case from the device. This should come off with ease.

Turn the device so the screen is facing away from you.

Using a philips head, size #00, screwdriver, remove the screws in each corner of the plastic casing.(total of 4 screws)

Remove the device casing using a small plastic pry bar.

After loosening the back cover, remove it from the device so you can get at the innards.

Use the Philips #00 screwdriver to remove the 5 screws from the motherboard

De-solder the grey wire from motherboard

Use tweezers to peel off all yellow tape from the motherboard

Remove all three ribbon cables from the motherboard by lifting up the locking tabs.

Use tweezers to pull the ribbon cable out of the locking tab's slot

Lift motherboard to separate it the from the case shell.