跳转到主内容

简介

Today we are going to repair the speaker system in the phone. This may be due to simple wire disconnections and may require soldering or a replacement of the system.

配件

没有特定配件。

  1. Slide the notch downward while pulling the back cover off to remove it. Slide the notch downward while pulling the back cover off to remove it. Slide the notch downward while pulling the back cover off to remove it.
    • Slide the notch downward while pulling the back cover off to remove it.

  2. Use your fingers to push the battery upward from the bottom. Lift upwards to remove the battery. Lift upwards to remove the battery.
    • Use your fingers to push the battery upward from the bottom.

    • Lift upwards to remove the battery.

  3. Unscrew the antenna in a counter-clockwise fashion. Remove the aluminum cover.
    • Unscrew the antenna in a counter-clockwise fashion.

    • Remove the aluminum cover.

  4. iPhone 电池维修工具包

    只要 $29.99

    Buy Now

    iPhone 电池维修工具包

    只要 $29.99

    Buy Now
  5. Unscrew the 3 screws shown. Lift up the right part of the Nextel logo and unscrew the screw underneath. Lift up the right part of the Nextel logo and unscrew the screw underneath.
    • Unscrew the 3 screws shown.

    • Lift up the right part of the Nextel logo and unscrew the screw underneath.

  6. DO NOT force the cover off as it could damage the ribbon cable! Gently lift the back cover off.
    • DO NOT force the cover off as it could damage the ribbon cable!

    • Gently lift the back cover off.

  7. Carefully pry off the connection between the headphone jack and logic board. Carefully pry off the connection between the headphone jack and logic board. Carefully pry off the connection between the headphone jack and logic board.
    • Carefully pry off the connection between the headphone jack and logic board.

  8. Use the prying tools to wedge out the circular part of the speaker system. Carefully pull out the wiring and circuit board attached to the speaker system using a prying tool or tweezers. Carefully pull out the wiring and circuit board attached to the speaker system using a prying tool or tweezers.
    • Use the prying tools to wedge out the circular part of the speaker system.

    • Carefully pull out the wiring and circuit board attached to the speaker system using a prying tool or tweezers.

结论

To reassemble your device, follow these instructions in reverse order.

Jorge

于2010年04月14日注册

4 信誉积分

创作了4篇指南

团队

Cal Poly, Team 29-61, Johann Spring 2010 Cal Poly, Team 29-61, Johann Spring 2010 的会员

CPSU-JOHANN-S10S29G61

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 1,125