简介

This repair guide will give instructions on how to remove the Macintosh PowerBook 1400c RAM.

配件

无需配件。

  1. Turn the device upside down and then locate the battery latch near the front of the device.
    • Turn the device upside down and then locate the battery latch near the front of the device.

  2. Slide the latch to the left to release the battery.
    • Slide the latch to the left to release the battery.

    • Continue holding the latch then gently pull the battery out of the device.

    • Place the battery in a safe location.

    • Locate the CD-ROM Drive latch.

    • Slide the latch to the right to release the CD ROM drive.

    • Continue holding the latch then gently pull the CD-ROM Drive out of the device.

    • Place the CD ROM drive in a safe location.

    • Locate the speaker cover.

    • Press firmly on each end of the speaker cover and slide it to the left.

    • Gently lift the speaker cover to remove it.

    • Lift the keyboard up from the back using a spudger(wedge side).

    • Gently lift the keyboard until only the ribbon cable remains attached.

    • Tilt the keyboard away from the screen.

    • Locate the six screws that secure the heatsink.

    • Remove the six screws from the heatsink using the Philips #1 screwdriver.

    • Lift the heatsink from the side closest to the laptop screen.

    • Remove the heatsink.

    • Gently pull up on the beige ribbon lock until it moves a short distance on both sides to separate the ribbon cable from the connector.

    • Detach the ribbon cable.

    • Remove the keyboard.

    • Identify RAM Memory stick

    • These are the upgradeable RAM Memory sticks, they must be removed first

    • Gently grasp the ram on the far end as shown in the picture and then pull up and away from the right side of the computer

    • Remove the upgradeable RAM stick

    • If the upgradeable RAM stick is all you are repairing you can end the guide here, however to remove the factory installed RAM please continue

    • Gently grasp the factory installed RAM by grabbing each end as shown in the picture and pull the stick directly up

    • Remove the factory installed RAM memory module

结论

To reassemble your device, follow these instructions in reverse order.

4等其他人完成本指南。

Kian Dinyari

于2011年04月07日注册

125 信誉积分

撰写一个指南

团队

Cal Poly, Team 10-39, Forte Spring 2011 Cal Poly, Team 10-39, Forte Spring 2011 的会员

CPSU-FORTE-S11S10G39

5 名成员

创作了6篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 14

总计 2,925