简介

This guide will detail the steps necessary to remove the keyboard from the Lenovo Essential G560 laptop. Please note that this is not an easy process and may take a bit of patience, especially when reinstalling or installing the new keyboard.

Turn off the computer.
  • Turn off the computer.

  • Disconnect the charging cable from the computer.

  • Failure to unplug the cable could result in electric shock.

  • Flip the computer upside down.

添加评论

Locate the two switches that lock the battery. Push the right-hand switch outward into the "unlocked" position. Locate the two switches that lock the battery. Push the right-hand switch outward into the "unlocked" position.
  • Locate the two switches that lock the battery. Push the right-hand switch outward into the "unlocked" position.

添加评论

Push and hold the left hand switch outward in the "unlocked" position, then gently slide the battery away from the computer.
  • Push and hold the left hand switch outward in the "unlocked" position, then gently slide the battery away from the computer.

添加评论

Remove the seven 5.3 mm Phillips  #1 screws holding the back panel in place.
  • Remove the seven 5.3 mm Phillips #1 screws holding the back panel in place.

添加评论

父亲节礼物指南
让我们不只为我们的父亲庆祝——让我们为曾教导我们维修的所有导师们庆祝!
父亲节礼物指南
向那些教我们维修的人表示敬意。
Pull the back panel off using the highlighted tab. The tab should give you enough leverage to pull the panel off smoothly. If the back panel is difficult to remove and feels like it is going to break, DO NOT force it. Check to confirm that all the screws are removed before attempting again.
  • Pull the back panel off using the highlighted tab. The tab should give you enough leverage to pull the panel off smoothly.

  • If the back panel is difficult to remove and feels like it is going to break, DO NOT force it. Check to confirm that all the screws are removed before attempting again.

添加评论

The computer should be open with many of the internal components shown. You can now access the hard drive, the RAM, and the keyboard.
  • The computer should be open with many of the internal components shown. You can now access the hard drive, the RAM, and the keyboard.

添加评论

Remove the two 5.3 mm Phillips #1 screws from the underside of the laptop computer.
  • Remove the two 5.3 mm Phillips #1 screws from the underside of the laptop computer.

  • Remove the 4.4 mm Phillips #1 screw located next to the Fan Assembly.

添加评论

Flip the computer over.
  • Flip the computer over.

  • Using the plastic opening tool, push in the four small, plastic tabs located at the top of the keyboard.

添加评论

Remove the keyboard by gently pulling the top loose, and then lifting the keyboard out.
  • Remove the keyboard by gently pulling the top loose, and then lifting the keyboard out.

  • While this step can be accomplished using your hand, it may be easier to use a spudger or plastic opening tool.

添加评论

Lift the keyboard up from the bezel.
  • Lift the keyboard up from the bezel.

  • Push the gray latch on the keyboard cable ZIF connector forward to unlock it.

  • Carefully pull the keyboard cable from its socket.

  • Be very careful while unlatching the lock on the keyboard cable ZIF connector. It is extremely delicate and can easily break.

This step need more detailed explanation

(with additional pictures) because it

crucial.

Anthony

Anthony Pek - 回复

结论

To reassemble your device, follow these instructions in reverse order.

10等其他人完成本指南。

Dennis Wong

于2013年01月11日注册

468 信誉积分

创作了5篇指南

团队

Cal Poly, Team 18-40, Regan Winter 2013 Cal Poly, Team 18-40, Regan Winter 2013 的会员

CPSU-REGAN-W13S18G40

5 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 5

过去的7天: 24

过去的30天: 89

总计 15,547