简介

The following guide will show the complete tear down of the phone in order to replace the internal phone casing.

Remove the battery cover by placing your thumb on the small ridge near the top of the phone back and push downward, exposing the battery.
  • Remove the battery cover by placing your thumb on the small ridge near the top of the phone back and push downward, exposing the battery.

  • Our device did not come with a battery cover so it is not shown here.

  • Remove the battery using your finger to pry it out of the battery housing.

添加评论

Remove the (2) rubber screw covers located near the hinge of the phone using tweezers or a thumb tack.
  • Remove the (2) rubber screw covers located near the hinge of the phone using tweezers or a thumb tack.

  • Unscrew the (4) 3.6mm screws using a #00 Phillip's head screw driver.

添加评论

  • Carefully pry off the phone's backing using a plastic opening tool.

  • Slip the tool into the crack between the keypad (front panel) and the back panel.

  • Slide the tool along the sides of the phone to detach the tabs holding the backing on.

添加评论

  • Peel back the sticker with tweezers and hold it back with your finger.

  • Use the tweezers to lift the display adapter off the logic board.

添加评论

  • Lift the mother board out of the phone casing.

  • The keyboard can be easily removed once the mother board is out of the phone.

添加评论

  • Carefully pry off the black plastic screen cover using the iSesamo tool or another thin, flat tool.

  • The screen cover is adhered to the phone and may take some effort to pry off. If it is too difficult to remove, heat the screen with a hair dryer on low for 30 seconds to soften the adhesive.

添加评论

  • Unscrew the (4) 3.6mm screws near each corner of the phone's display panel by using a #00 Phillips head screwdriver.

  • The bottom two screws may have small rubber covers that you can remove using tweezers.

添加评论

  • Pry off the front panel of the phone using a Plastic Opening Tool.

    • Push the tool into the crack along the side of the phone.

    • Slide the tool along the crack to detach the tabs holding the backing on the phone.

添加评论

  • Use the tweezers to lift the display adapter off the screen component.

添加评论

  • Using tweezers remove the speaker from its casing.

  • The speaker is adhered to the phone casing so it will take a small amount of force to remove it.

添加评论

  • Remove the earpiece and gyroscope by lifting them out of the phone casing using tweezers.

  • The earpiece and gyroscope are adhered to the phone casing so it will take a small amount of force to remove them.

  • Be careful when removing these components as the connecting wires are easily broken/disconnected.

添加评论

  • Lift the screen components out of the phone.

添加评论

  • The phone is now fully disassembled.

  • Replace the parts indicated with your new phone casing.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Henry

于2012年04月12日注册

181 信誉积分

创作了3篇指南

团队

Cal Poly, Team 7-33, Maness Spring 2012 Cal Poly, Team 7-33, Maness Spring 2012 的会员

CPSU-MANESS-S12S7G33

4 名成员

创作了10篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 446