加入维修社区 - 创建账户

简介

If you are having problems connecting to your Jabra Elite 85H headphones there could be a problem with the Bluetooth module. Follow this guide to correctly disassemble the headsets and repair the module. This guide takes you step by step on how to do it.

你所需要的

1. 步骤 1 Bluetooth Module
  Remove each ear cushion by hooking your fingers along the inside of the ear cushion and pulling up and away from the ear cup.
  
  If the cushion does not fully release, move your hand to the opposite side and pull up inn the same manner.
  翻译
  
  询问修复机器人
  
  添加评论
  
  1024
2. 步骤 2
  The foam inserts and backing tape are very delicate, take your time when removing them and be careful to not rip or tear the material.
  
  Using the small plastic spudger to assist, begin lifting up and removing the foam inserts with attached backing tape.
  翻译
  
  询问修复机器人
  
  添加评论
  
  1024
3. 步骤 3
  Repeat previous steps on other side.
  翻译
  
  询问修复机器人
  
  添加评论
  
  1024
5. 步骤 4
  Unscrew and remove the four T6 screws holding the speaker in place.
  翻译
  
  询问修复机器人
  
  添加评论
  
  1024
6. 步骤 5
  Tilt the headphones over so that the speaker tilts out of the plastic holder.
  
  Repeat for both sides.
  翻译
  
  询问修复机器人
  
  添加评论
  
  1024
7. 步骤 6
  Remove the two screws holding the upper and lower circuit boards in place.
  翻译
  
  询问修复机器人
  
  添加评论
  
  1024
8. 步骤 7
  Remove the two attached circuit boards from the headphone housing.
  
  De-solder Bluetooth Module from control board to replace.
  翻译
  
  询问修复机器人
  
  添加评论
  
  1024