简介

Use this guide if your Huawei Union will not charge when plugged into a charger or begins losing charge faster than previously observed.

  1. Wedge your thumb nail, or the flat end of a spudger, into the bottom left corner and pry off.
    • Wedge your thumb nail, or the flat end of a spudger, into the bottom left corner and pry off.

    添加评论

  2. Use the flat end of a spudger, or fingernail, to lift up the battery and pull out.
    • Use the flat end of a spudger, or fingernail, to lift up the battery and pull out.

    添加评论

    • Remove the thirteen 3mm Phillips #00 screws from the back panel.

    添加评论

    • Use the flat end of a spudger to pry off the back panel.

    添加评论

    • Remove a single 3mm Phillips #00 screw from the motherboard.

    添加评论

    • Using the flat end of a spudger to disconnect the motherboard ribbon cable.

    添加评论

    • Firmly hold the second ribbon cable's plastic film cover and pull up to disconnect.

    添加评论

    • Wedge the flat end of a spudger underneath the motherboard and pry upwards to separate it from the frame.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Brittany Achor

于2018年02月14日注册

651 信誉积分

创作了6篇指南

团队

USF Tampa, Team S1-G1, Nance Spring 2018 USF Tampa, Team S1-G1, Nance Spring 2018 的会员

USFT-NANCE-S18S1G1

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 8

总计 80