How to open the Huawei Watch GT 3 (46mm) for Repairs

简介

Use this guide to open your Huawei Watch GT 3 (46 mm) for repairs.

你所需要的

步骤 1 Remove the watch band

How to open the Huawei Watch GT 3 (46mm) for Repairs, Remove the watch band: 步骤 1 中的图像 1，1

Before starting repairs, take your watch off the charger and power it down.
Remove the watch band.

编辑

步骤 2 Unfasten the back cover screws

How to open the Huawei Watch GT 3 (46mm) for Repairs, Unfasten the back cover screws: 步骤 2 中的图像 1，1

Remove the four 3.7 mm-long Torx T2 screws securing the back cover.

编辑

步骤 3 Pry up the rear panel

How to open the Huawei Watch GT 3 (46mm) for Repairs, Pry up the rear panel: 步骤 3 中的图像 1，2

How to open the Huawei Watch GT 3 (46mm) for Repairs, Pry up the rear panel: 步骤 3 中的图像 2，2

Insert the edge of a spudger into the the loudspeaker opening at the bottom edge of your watch.
When prying up the back cover put a finger on top or the edge of it and hold it down. Too much force during the prying procedure may lead to popping off the back cover too quickly and tearing the rear panel assembly cable.
The plastic clamps holding the back cover in place sit very tight and may require some force during the prying procedure.
Use a spudger to pry up the rear panel of your Huawei watch GT 3.
Don't try to remove the back cover assembly all the way yet, it's still connected to the daughterboard.

编辑

步骤 4 Swing open the rear panel assembly

How to open the Huawei Watch GT 3 (46mm) for Repairs, Swing open the rear panel assembly: 步骤 4 中的图像 1，2

How to open the Huawei Watch GT 3 (46mm) for Repairs, Swing open the rear panel assembly: 步骤 4 中的图像 2，2

Carefully swing the rear panel assembly open to an upward position.
To avoid straining the rear panel assembly cable during following repair steps you can lean it against an object of your choice.

编辑

结论

If possible, turn on your device and test your repair before installing new adhesive and resealing.

Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

另外一个人完成了本指南。