简介

This guide is one of the longer processes, second only to the Logic Board, or the screen. Have a reasonably long time set aside to complete this guide.

Carefully pull the rear cover from the back of the phone.
  • Carefully pull the rear cover from the back of the phone.

  • Place a finger beneath the small lip on the left side of the battery.

添加评论

Lay the phone down on it's screen. Lift up on the lip and pull the battery from the phone.
  • Lay the phone down on it's screen.

  • Lift up on the lip and pull the battery from the phone.

添加评论

Remove the four black 3.5mm T5 screws from the back of the phone. Remove the four black 3.5mm T5 screws from the back of the phone.
  • Remove the four black 3.5mm T5 screws from the back of the phone.

添加评论

Mac RAM 套件
加速你的Mac。充分利用它的内存。
Mac RAM 套件
从Mac中清理出更多内存。
Insert the flat end of a spudger between the midframe and the display. Slide the spudger along the seam between the frame and the display.
  • Insert the flat end of a spudger between the midframe and the display.

  • Slide the spudger along the seam between the frame and the display.

  • Using the spudger for leverage, carefully pry the midframe away from the display assembly.

    • This process will take some effort. Continue to pry slowly and carefully until the frame begins to detach.

  • As it releases, pull the midframe away from the phone.

  • The volume control tab may fall off during removal. It can be easily reattached.

添加评论

Disconnect the flash cable from its socket in the bottom of the motherboard. Carefully pull the cable from its groove in the frame, working your way back to the camera. Carefully pull the cable from its groove in the frame, working your way back to the camera.
  • Disconnect the flash cable from its socket in the bottom of the motherboard.

  • Carefully pull the cable from its groove in the frame, working your way back to the camera.

添加评论

Pull the camera flash and cover off of the board. You may need to peel back the sticker that sits behind the battery. Work carefully. Excessive force can damage the camera or motherboard.
  • Pull the camera flash and cover off of the board.

    • You may need to peel back the sticker that sits behind the battery.

  • Work carefully. Excessive force can damage the camera or motherboard.

添加评论

Around the camera is a thin shielding. Remove it with tweezers.
  • Around the camera is a thin shielding. Remove it with tweezers.

  • Using tweezers, remove the primary camera.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Sam Luedloff

于2011年04月12日注册

715 信誉积分

创作了3篇指南

团队

Cal Poly, Team 24-55, Amido Spring 2011 Cal Poly, Team 24-55, Amido Spring 2011 的会员

CPSU-AMIDO-S11S24G55

5 名成员

创作了8篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 8

总计 7,688