简介

The touchscreen is what you use to interact with the printer. If the touchscreen is malfunctioning, the HP OfficeJet 4650's interactive functions will not work. This guide will show you how to replace the touchscreen.

Open the cartridge access door by using putting one hand on the grooves of each side and pulling up.
  • Open the cartridge access door by using putting one hand on the grooves of each side and pulling up.

添加评论

Using the 2.0mm screwdriver, remove the 14mm hex screw that binds the front cover to the printer body by turning the screw counterclockwise.
  • Using the 2.0mm screwdriver, remove the 14mm hex screw that binds the front cover to the printer body by turning the screw counterclockwise.

添加评论

  • Release the front panel from its internal hooks by applying a little force and sliding the front panel to the right.

  • Push the panel upward to remove it from the printer.

  • There is a connector attached to the back of the panel. Flip the front cover towards you gently and proceed to the next step.

添加评论

  • Remove the connector that is attached to the screen's circuit board by pinching the blue part of the connector with two fingers and pulling it away from the circuit board.

添加评论

  • Remove the other connector that is attached to the screen's circuit board by pinching the blue part of the connector with two fingers and pulling it away from the circuit board.

添加评论

  • Unclip the yellow connector by lifting up the grey piece with your finger.

  • The yellow connector will pop right up when the grey piece is unclipped.

添加评论

  • Unclip the yellow connector by lifting up the grey piece with your finger.

  • The yellow connector will pop right up when the grey piece is unclipped.

添加评论

  • Using the Torx T6 hex screwdriver, remove the 7.0mm screws that bind the screen to the printer body by turning the screws counterclockwise.

  • Using the Torx T6 hex screwdriver, remove the 7.0mm screws that bind the green circuit board to the screen by turning the screws counterclockwise.

添加评论

  • Remove the circuit board by lifting it off the screen in order to get the screen on its own.

  • Pull the screen off the front panel cover.

  • The clear plastics pieces will easily fall off when the screen is lifted off. Do not lose them.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Stephanie Carpintero

于2018年01月24日注册

922 信誉积分

创作了5篇指南

团队

Cal Poly, Team S19-G6, Livingston Winter 2018 Cal Poly, Team S19-G6, Livingston Winter 2018 的会员

CPSU-LIVINGSTON-W18S19G6

3 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 16

总计 176