难度
简单
步骤
6
所需时间
10分钟
- Battery and Service Access Cover 4个步骤
- RAM 2个步骤
标记错误
本指南需要更好的标记。请帮助纠正或制作一些标记批注。
详尽分析
本指南中的步骤应该被分开，并制作成一系列的前提条件指南。
特色指南
iFixit的工作人员认为该指南特别酷。
简介
Use this guide to replace your RAM Card. Replacing your RAM card for one of higher capacity will allow your system to perform better.
工具
无需工具。
-
Close the laptop and turn it over, so that the underside is up and the silver battery bay is facing towards you.
-
Locate the battery locking latch on the bottom right corner and slide it inward to unlock the battery.
-
Locate the battery release latch on the bottom left and slide it inward.
-
Pull the battery towards you to remove it from the laptop.
-
Locate the service access cover release lever and slide it to the right.
-
While holding the lever to the right, lift up the laptop's bottom cover gently and remove the cover from the laptop.
-
If you are performing any installations after the battery, orient the computer so that the underside is up, and the battery port is facing away from you.
-
Using your fingers, pull the two white clips (tabs) on both sides of the RAM away from each other. Keep pulling the clips until the RAM pops up
-
Grab the edges of the module and gently lift it from the slot.
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
2等其他人完成本指南。
团队
Cal Poly, Team 3-23, Amido Fall 2012 Cal Poly, Team 3-23, Amido Fall 2012 的会员
CPSU-AMIDO-F12S3G23
4 名成员
创作了6篇指南
