HP 15-R263DX USB Port Replacement

最后更新于 June 26, 2018

15分钟

中等

简介

A USB port can be diagnosed as faulty when the computer no longer detects when a device is connected via USB. Ensure the USB connections are free of debris before declaring the port as faulty.

你所需要的

工具

步骤 1 Battery

HP 15-R263DX USB Port Replacement, Battery: 步骤 1 中的图像 1，2

HP 15-R263DX USB Port Replacement, Battery: 步骤 1 中的图像 2，2

Eject the battery from the computer by sliding the two clips on the bottom of the computer toward the center of the computer.
Slide the battery out as shown in the picture.

编辑

步骤 2 Optical Drive

HP 15-R263DX USB Port Replacement, Optical Drive: 步骤 2 中的图像 1，2

HP 15-R263DX USB Port Replacement, Optical Drive: 步骤 2 中的图像 2，2

Using a Phillips #1 screwdriver, remove the small screw next to the disc engraving shown in the picture.

编辑

步骤 3

Gently slide the optical drive out of the side of the computer.

编辑

步骤 4 HP 15-R263DX Disassembly

HP 15-R263DX USB Port Replacement, HP 15-R263DX Disassembly: 步骤 4 中的图像 1，2

HP 15-R263DX USB Port Replacement, HP 15-R263DX Disassembly: 步骤 4 中的图像 2，2

Locate the two corner grips on the hinge side of the computer.
Using a metal spudger, remove the two corner grips to reveal the screws.

编辑

步骤 5

Remove the 11 small screws on the bottom of the computer that are shown in the picture.

编辑

步骤 6

Remove the 2 small screws that are on the bottom side of the disc tray slot.
These screws are shorter and wider than the others.

编辑

步骤 7

Once the keyboard is loose, do not immediately pull away from computer. It is attached by the ribbon connector.
Using a spudger, pry around the edges of the keyboard until all clips are disengaged and the keyboard is loose from the computer.
To disconnect the ribbon connector, flip up the black clip shown in the picture.
Gently pull the ribbon until disconnected.

编辑

步骤 8

Disconnect the other two ribbon connectors underneath the keyboard by fliping up the black clips.
Remove the 4 small screws shown in the picture.

编辑

步骤 9

Disengage the face plate clips by prying the case away from around the outer edge of the face plate with a metal wedge.
The face plate can then be lifted away from the computer.

编辑

步骤 10 Hard Drive

HP 15-R263DX USB Port Replacement, Hard Drive: 步骤 10 中的图像 1，1

Remove the 2 black screws holding the hard drive to the computer frame.

编辑

步骤 11

Gently slide the hard drive away from the motherboard to disconnect it.
After it's disconnected, lift the hard drive up to remove it from the computer.

编辑

步骤 12 USB Port

HP 15-R263DX USB Port Replacement, USB Port: 步骤 12 中的图像 1，1

Remove the single screw holding the USB ports and chip into the computer.

编辑

步骤 13

Remove the chip by gently pulling it up and then away from the edge of the case.

编辑

步骤 14

Under the motherboard, disconnect the wire that runs to the USB chip.
You may need to pull or wedge the wire up from the case as a section of it is glued down.

编辑