简介

Installing upgraded memory.

Move the latch to the right of the battery to unlock.
  • Move the latch to the right of the battery to unlock.

添加评论

Slide the latch on the left directly below the battery to unlock and pull out the battery as shown.
  • Slide the latch on the left directly below the battery to unlock and pull out the battery as shown.

  • The latch must be held in position to remove the battery.

添加评论

  • Loosen the indicated Philips screw that connects the memory bay cover to the casing.

  • The indicated Philips screw does not come out of the cover.

添加评论

  • Lift and remove the cover using the spudger.

添加评论

  • Gently press the clip outwards.

    • The module will tilt up and can be pulled out of the slot.

  • There may be another memory module underneath so be sure to remove both.

添加评论

  • To insert a new memory, slide the module into the slot at a 30 to 45 degree angle.

    • Place the first module into the bottom slot then the next module into the top slot.

  • These slots are keyed so verify that you are sliding the module in one direction.

  • Verify that the new memory modules are designed for your specific Gateway Laptop.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

3等其他人完成本指南。

Diego Carteno

于2010年04月15日注册

247 信誉积分

创作了7篇指南

团队

Cal Poly, Team 24-20, Regan Spring 2010 Cal Poly, Team 24-20, Regan Spring 2010 的会员

CPSU-REGAN-S10S24G20

4 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 4

过去的30天: 12

总计 4,849