简介

Opening the Nuvi and replacing a broken/damaged display.

  1. Peel off the sticker from the bottom of the device to reveal two screws. Peel off the sticker from the bottom of the device to reveal two screws.
    • Peel off the sticker from the bottom of the device to reveal two screws.

  2. Remove two T5 Torx screws.
    • Remove two T5 Torx screws.

  3. Insert a plastic opening tool in the gap between the front and rear casing. Carefully work the tool around the gap, separating the two halves of the case.
    • Insert a plastic opening tool in the gap between the front and rear casing.

    • Carefully work the tool around the gap, separating the two halves of the case.

      • Keep the power switch in place while removing the rear case.

  4. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店

    善于维修,即天赋异禀。

    与 #ImAGenius 分享您的维修故事

    我们都是天才

    与 #ImAGenius 分享您的维修故事

  5. Apply pressure to the tabs holding the screen in place with the plastic opening tool
    • Apply pressure to the tabs holding the screen in place with the plastic opening tool

  6. Apply pressure to the same tabs again to remove the front of the screen. Apply pressure to the same tabs again to remove the front of the screen.
    • Apply pressure to the same tabs again to remove the front of the screen.

  7. Peel away the material holding the ribbon cable in place. Peeling the sticker halfway will allow you to access the ribbon cable. Removing it fully will allow you to detach the upper case from the lower case.
    • Peel away the material holding the ribbon cable in place.

    • Peeling the sticker halfway will allow you to access the ribbon cable. Removing it fully will allow you to detach the upper case from the lower case.

  8. Disconnect the ribbon cable from the logic board. Make sure to disconnect the cable from both ports.
    • Disconnect the ribbon cable from the logic board.

      • Make sure to disconnect the cable from both ports.

  9. The display consists of two screens which are held together by the ribbon. The display consists of two screens which are held together by the ribbon.
    • The display consists of two screens which are held together by the ribbon.

结论

To reassemble your device, follow these instructions in reverse order.

4等其他人完成本指南。

Nick

于2010年04月11日注册

7 信誉积分

撰写一个指南

团队

Cal Poly, Team 25-90, Amido Spring 2010 Cal Poly, Team 25-90, Amido Spring 2010 的会员

CPSU-AMIDO-S10S25G90

4 名成员

创作了9篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 9

总计 10,486