修复你的物品 社区 商店

Ematic Genesis Camera Replacement

简介

This guide will demonstrate the necessary steps in order to safely remove the camera from the Ematic Genesis Tablet.

你所需要的

  1. Ematic Genesis Camera Replacement, Ematic Genesis Casing: 步骤 1 中的图像 1，3 Ematic Genesis Camera Replacement, Ematic Genesis Casing: 步骤 1 中的图像 2，3 Ematic Genesis Camera Replacement, Ematic Genesis Casing: 步骤 1 中的图像 3，3

    • Unscrew the two (2) 1.3mm Phillips #00 screws found on the bottom edge of the tablet, where the power and volume buttons are located.

    编辑

  2. Ematic Genesis Camera Replacement: 步骤 2 中的图像 1，3 Ematic Genesis Camera Replacement: 步骤 2 中的图像 2，3 Ematic Genesis Camera Replacement: 步骤 2 中的图像 3，3

    • Insert plastic opening tool into the edge between the screen plate and the back plate to create a separation between the casings.

    • Insert the flat end of the spudger next to the plastic opening tool and carefully pry the edges apart. Continue this all around the edges until the casings separate.

    • There may be cracking sounds when prying them apart. If carefully done, this is only the locks coming apart and is not harmful.

    • Be careful when separating the two plates as they are connected by the speaker wires and could be disconnected during this process.

    编辑

  4. Ematic Genesis Camera Replacement: 步骤 3 中的图像 1，1

    • Remove back plate from screen plate and lay both down flat next to each other.

    • Be careful when separating the two plates as they are connected by the speaker wires and could be disconnected during this process.

    编辑

  5. Ematic Genesis Camera Replacement, Camera: 步骤 4 中的图像 1，2 Ematic Genesis Camera Replacement, Camera: 步骤 4 中的图像 2，2

    • Once the panels are separated, remove the tape holding down the ribbon connector that is connecting the camera to the motherboard.

    编辑

  6. Ematic Genesis Camera Replacement: 步骤 5 中的图像 1，2 Ematic Genesis Camera Replacement: 步骤 5 中的图像 2，2

    • Lift up the black lever of the connector that holds the camera ribbon in place.

    编辑

  7. Ematic Genesis Camera Replacement: 步骤 6 中的图像 1，2 Ematic Genesis Camera Replacement: 步骤 6 中的图像 2，2

    • Gently pull the ribbon out of the connector and lift the camera out of the casing.

    • There is adhesive holding the camera in the case. Pull up strong enough to separate the camera from the casing without damaging the components.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

作者

与3其他贡献者

Justin Rohrman

于03/23/15注册

745 声望

创作了6篇指南

徽章: 12

+ 9更多徽章

团队

Baylor, Team 4-3, Williams Spring 2015 Baylor, Team 4-3, Williams Spring 2015 的会员

BU-WILLIAMS-S15S4G3

3 名成员

创作了12篇指南

0条评论

添加评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 2

过去 30 天： 2

总计 144