Edwin the Duck Rubber Heart Power Button Replacement

Unscrew the four 9mm screws with a T8 bit

Remove the back plate off

Carefully take off the rubber skin.

Using the J1 bit, unscrew all six 9 mm screws that run along the border.

Use the plastic opening tool to open the inside of the duck.

Using the plastic opening tool pull up the black tab up until it stops.

Pull up the white cable tab up slowly

Use the J1 bit to unscrew all four 9 mm screws connected to the motherboard.

Use the J1 bit to unscrew both 9 mm screws attached to the white plastic plate

Lift up the motherboard and speaker and place it away and to the side like you see in the picture

Unscrew the two black 9 mm screws by using the J1 bit.

Remove the damaged rubber heart button and replace with a new rubber heart button.