加入维修社区 - 创建账户

简介

Over time, the buttons on your EasySMX X15 controller may become less responsive or get stuck. Replacing the buttons is a relatively simple process that you can do at home with a few basic tools. This guide will walk you through how to replace the buttons.

Note: You don't need to remove the battery as shown in Step 3. However, it is important to disconnect the battery from the board before you move on.

你所需要的

步骤 1 Bottom Casing

EasySMX X15 A,B,X,Y Buttons Replacement, Bottom Casing: 步骤 1 中的图像 1，2

EasySMX X15 A,B,X,Y Buttons Replacement, Bottom Casing: 步骤 1 中的图像 2，2

Use a Phillips #00 screwdriver to remove the four 9 mm screws from the bottom of the EasySMX X15.
Use an opening tool to gently pry between the seams of the controller to separate the lower and upper casings.
Be gentle when separating the lower casing from the upper casing to avoid breaking any of the plastic snap tabs.

翻译

步骤 2 Battery

EasySMX X15 A,B,X,Y Buttons Replacement, Battery: 步骤 2 中的图像 1，3

EasySMX X15 A,B,X,Y Buttons Replacement, Battery: 步骤 2 中的图像 2，3

EasySMX X15 A,B,X,Y Buttons Replacement, Battery: 步骤 2 中的图像 3，3

Push on alternating sides of the connector to disconnect the red battery cable from the board.
If that doesn't work, use a pair of tweezers to firmly grip the sides of the connector and pull straight away from the socket. Hold the tweezers closer to the connector to get a better grip.
Pull from the tab, not the cables, to avoid damaging them.

翻译

步骤 3

Use a spudger to pry the battery loose from the controller.
The battery is glued onto the control board, so it may take a bit of work to release it from the adhesive.
Remove the battery.
Don't bend or pierce the battery. If the battery is swollen, follow the guidelines outlined in this article.

翻译

步骤 4 Main Board

EasySMX X15 A,B,X,Y Buttons Replacement, Main Board: 步骤 4 中的图像 1，1

Disconnect the vibration motor cables from the connectors on the circuit board.
Use a Phillips #00 screwdriver to remove six, 6mm screws from the board.

翻译

步骤 5

Gently lift the board away from the upper casing, maneuvering it around the triggers by lifting it from the bottom, away from the upper casing.

翻译

步骤 6 A B X Y Buttons

EasySMX X15 A,B,X,Y Buttons Replacement, A B X Y Buttons: 步骤 6 中的图像 1，2

EasySMX X15 A,B,X,Y Buttons Replacement, A B X Y Buttons: 步骤 6 中的图像 2，2

Remove the buttons from inside of the top case.
Check the silicone membranes. If your controller has silicone membranes or conductive pads beneath the buttons, ensure these are properly positioned over the buttons. If necessary, replace worn membranes with new ones.