跳转到主内容

简介

This guide will show you how to replace a defective gear lock button. With only a few steps and a few tools you will be able to open up the device and gain access to the faulty button. The button can then be easily swapped out for a new one.

配件

没有特定配件。

  1. Locate the battery at the back of your Dremel. Firmly grasp the battery on both sides and pull. It should easily come out of the battery well.
    • Locate the battery at the back of your Dremel. Firmly grasp the battery on both sides and pull. It should easily come out of the battery well.

  2. Remove the ring located around the speed selector switch by pulling apart on either side. This should require very minimal force.
    • Remove the ring located around the speed selector switch by pulling apart on either side. This should require very minimal force.

  3. Remove the collar wrench by pushing the gear lock button. Continue to hold this button as you rotate the wrench counter-clockwise until it is removed.
    • Remove the collar wrench by pushing the gear lock button. Continue to hold this button as you rotate the wrench counter-clockwise until it is removed.

  4. Remove the metal clasp from the battery well. This piece helps hold the plastic shell of the device together. Pry it out by gently applying some force with a screwdriver.
    • Remove the metal clasp from the battery well. This piece helps hold the plastic shell of the device together. Pry it out by gently applying some force with a screwdriver.

  5. Remove the 5 torx screws using a t9 screwdriver head. Now pull apart the plastic shell of the device. If you are not able to, review the previous steps as you may have missed one. Now pull apart the plastic shell of the device. If you are not able to, review the previous steps as you may have missed one.
    • Remove the 5 torx screws using a t9 screwdriver head.

    • Now pull apart the plastic shell of the device. If you are not able to, review the previous steps as you may have missed one.

  6. Remove the faulty gear lock button. It should come out of the device easily with no force needed.
    • Remove the faulty gear lock button. It should come out of the device easily with no force needed.

结论

To reassemble your device, follow these instructions in reverse order.

connor anisko

于2016年03月09日注册

289 信誉积分

创作了2篇指南

团队

UMass Dartmouth, Team 2-8, Isaacson Spring 2016 UMass Dartmouth, Team 2-8, Isaacson Spring 2016 的会员

UMASSD-ISAACSON-S16S2G8

3 名成员

创作了5篇指南

I’m assuming the issue I have is a faulty gear-lock button (that, or the locking gear that it restricts when depressed). If so, did you find a replacement button from the manufacturer? In my experience, they rarely offer repair parts themselves.

Robert - 回复

I also don’t understand why there was a flag claiming that this should be broken into separate guides. People aren’t THAT stupid, I hope.

Robert - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 13

总计 372