Canon PowerShot A3400 IS Flash Assembly Replacement

Place thumb on area right next to where it says open and slide to the right to open.

Remove the battery by pushing the orange object outwards; the battery will spring up and out.

Remove the two 5.00 mm screws in the bottom of the casing with a Philips #000 screwdriver

Place the camera on to the side that has the image stabilizer label.

Remove the 5.00 mm screws that are on this side using the screwdriver.

Place camera on to the side with the A/V Out Digital Cover facing up.

Remove this visible 5.00 mm screw.

Pull the A/V Out Digital cover back to uncover the next step.

Remove the 5.00 mm screw from behind the cover.

Make sure the battery cover is open.

Turn the camera onto the side with the A/V out Digital cover.

Use your finger to pull this tab to the right.

Remove the lens side by using your fingers or a spudger to pry it gently open.

Using your fingers, pull the screen side gently off.

Remove the three 5 mm screws

Remove the screen by pulling at the two points as shown.

Remove the metal plate with the plastic opening tool.

Remove the 5 mm screw

Gently pull the flash assembly away.