简介

This guide will lead you through the steps for replacing the keyboard on your Brother PT-D200.

  1. Flip the device over and press down on the indication arrows located at the top center of the back cover and pull it open.
    • Flip the device over and press down on the indication arrows located at the top center of the back cover and pull it open.

  2. Remove the six AAA batteries.
    • Remove the six AAA batteries.

  3. Use the Helping Hand 1/4" screwdriver to unscrew the six 3/16" corner screws.
    • Use the Helping Hand 1/4" screwdriver to unscrew the six 3/16" corner screws.

  4. 所有超过US$100或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  5. Close the back cover and then flip the device over and separate the top half from the bottom half as shown.
    • Close the back cover and then flip the device over and separate the top half from the bottom half as shown.

    • Be gentle when lifting the top of the device, there is a ribbon cable attaching the two halves together.

  6. On the top portion of the device there are four grey clips locking the faceplate in place.  The two top clips are circled in the image. The two others are located in the other corners of the device.
    • On the top portion of the device there are four grey clips locking the faceplate in place. The two top clips are circled in the image. The two others are located in the other corners of the device.

  7. Pull the clips inward two at a time, first the top then the bottom, to snap the face plate off. Pull the clips inward two at a time, first the top then the bottom, to snap the face plate off.
    • Pull the clips inward two at a time, first the top then the bottom, to snap the face plate off.

  8. Peel off the rubber keyboard of the device. Peel off the rubber keyboard of the device.
    • Peel off the rubber keyboard of the device.

结论

To reassemble your device, follow these instructions in reverse order.

[deleted]

于2014年01月24日注册

301 信誉积分

创作了3篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 5

总计 259