Azpen A720 Touch Screen Replacement

简介

The touchscreen is embedded in the outer front casing of your Azpen A720 tablet. If the front touch screen is cracked or is not responding properly to touch, you should replace it. This replacement is moderately difficult, and it may take some time and patience, but this guide will help you through the process of replacing the tablet's front casing and touch screen.

你所需要的

步骤 1 Back Cover

Azpen A720 Touch Screen Replacement, Back Cover: 步骤 1 中的图像 1，2

Azpen A720 Touch Screen Replacement, Back Cover: 步骤 1 中的图像 2，2

Use a Phillips #00 screwdriver to remove the two 4mm screws found on the top edge of the tablet near the power button.

编辑

步骤 2

Azpen A720 Touch Screen Replacement: 步骤 2 中的图像 3，3

Use the plastic opening tool to pry the white back from the silver frame. Start near the micro SD slot.
Slide the plastic opening tool around the perimeter of the casing until the back is disconnected.

编辑

步骤 3

Remove the rear casing.

编辑

步骤 4 Touch Screen

Azpen A720 Touch Screen Replacement, Touch Screen: 步骤 4 中的图像 1，3

Azpen A720 Touch Screen Replacement, Touch Screen: 步骤 4 中的图像 2，3

Azpen A720 Touch Screen Replacement, Touch Screen: 步骤 4 中的图像 3，3

Use the plastic opening tool to gently lift the release lever for the ZIF cable.
The ZIF connector is delicate. Be careful not to damage the tab!

编辑

步骤 5

Gently remove the ZIF cable from the connector.

编辑

步骤 6

Disconnect the second ZIF connector using the same method detailed earlier.

编辑

步骤 7

Azpen A720 Touch Screen Replacement: 步骤 7 中的图像 3，3

Locate the microphone. It is at the top of the device and next to the audio jack.
Using tweezers, gently remove the microphone.
Remember to reinsert the microphone when reassembling!

编辑

步骤 8

Azpen A720 Touch Screen Replacement: 步骤 8 中的图像 3，3

Remove the three 4mm Phillips #00 screws securing the motherboard in place.

编辑

步骤 9

Azpen A720 Touch Screen Replacement: 步骤 9 中的图像 3，3

Remove the motherboard from the casing, being careful not to damage the remaining wires.
It's okay if the buttons fall out of the case.
Flip the motherboard so it rests upside down and out of the way of the metal backing.

编辑

步骤 10

Starting at the edge, use a plastic opening tool to carefully pry the front casing off of the metal backing.
Leave the plastic opening tool in place underneath the metal backing to prop it up.
Move the motherboard out of the way as needed.

编辑

步骤 11

Using a second plastic opening tool, pry the adjacent side of the metal backing from the front casing/touch screen.
Pry close to the plastic tabs so you do not break them.
Leave the plastic opening tool in place underneath the metal backing to prop it up.

编辑

步骤 12

Remove the first plastic opening tool and use it to pry along the second edge.
Slide the tool along the edge until it is close the next tab, and gently pry the metal up.

编辑