声誉积分: 13
2
Samsung
washing machine has no hot water. I have tested thermistor it appears fine. ohms resistance drops with hand heat. element is fine 2.2 ohms but when on washing cycle no hot water is created ive attached crocerdial clips to power input on element no voltage detected on terminal on heat part of cycle . I have replaced pcb board b dc92 02140a note no error coded shown on machine. I am out of ideas
声誉积分: 13
2
in the end it was the wiring loom i had to strip down to locate and bridge broken wires.movement between drum and loom. I hope it helps others
这个答案有帮助吗？
@philippric92934 and that is the way to fix things :-) Great job and just in time to finish the weekend laundry!
声誉积分: 4千
3
4
Have you checked the filter element in the hot water hose?
If it is not that, then it is likely a bad water valve. There are 2. One for hot and one for cold.
这个答案有帮助吗？
Uk machines use a single cold feed in the end it was a wiring loom issue. after stripping down the loom part of the thermistor circuit in the loom had snapped causing open circuit
过去 24 小时： 0
过去 7 天： 4
过去 30 天： 5
总计 59
