跳转到主内容

Repair guides and support for top and front loading Whirlpool brand washers.

428 个问题 查看全部

Won’t drain error f21

Maytag epic z model Mhwz600tk00

Will not finish cycle get error code f21 which indicates.... a drainage issue... taken apart drained, cleared coin catch removed hose and verified no other blockage. Still won’t pump out. Ran with pump removed from coin catch and motor spins fine. Also tried running with hose into tub instead of into drain directly. Maytag is no help

Any ideas?

回答此问题 我也有这个问题

这是一个好问题吗?

得分 0
添加一条评论

2个答案

The F21 error on this line of washers is the machines way of saying the water took to long to drain from the tub. This could be a problem with one of the washer parts including the drain pump itself, how the drain hose enters the stand pipe, or maybe even something is stuck somewhere in the drain system and is preventing the water from flowing properly. Not quite an emergency, but it is an indication of a problem and a problem that can lead to something bigger if not looked into.

这个答案有帮助吗?

得分 0

2条评论:

So being that the hose has been visually inspected, as in removed straightened and determined there is no blockage. The motor does in fact spin and there is not restriction between the drum and coin catch what could be causing it to not drain. I feel like there is something strang. It is inoperable right now since it can’t drain for a rinse cycle or whatever

完成的

@thompson22 Eric Is this a new unit or set up or did it just start happening slowly or suddenly?

完成的

添加一条评论

[I know this was discussed back in 2018 but I am currently having same issue and after cleaning the filter, drain hose, etc. I was warned of the below issue...

I cleaned washer with vinegar (without clothes), then again with only water]

The F21 error code SOMETIMES alerts to indicate "to much suds/wrong detergent".

Which leads to excessive suds causing the error code.

The washer should automatically fix after a long repetitive cycle...

Errorcode continually flashes until it fixes the sud issue, which is....

automatically drains, rinses, & repeats... until excess sud nonsense is resolved

**the code will reset after the washer resolved issue

Also [non-spill bleach] can be the cause of your "excess sud" issue.

Good luck, hope it helps

这个答案有帮助吗?

得分 0
添加一条评论

添加你的答案

Eric thompson 将永远感激不已
浏览统计数据:

过去 24 小时: 1

过去 7 天: 4

过去 30 天: 10

总计 1,698