跳转到主内容

7.9 inch display / Model A1432 / Available in black or white / Announced October 23rd, 2012 / 16, 32, or 64 GB capacity

220 个问题 查看全部

Ipad Mini unresponsive in every way

hi

my sons ipad min was dropped and the screen cracked. It was left for a while as we went on holiday. Came back and tried to charge it up but it wouldnt charge and its not recognised in itunes either. Ive tried a hard reset whilst its plugged into itunes but nothing.

Any help appreciated

已回答! 显示答案 我也有这个问题

这是一个好问题吗?

得分 0
1条评论

Update:

I dismantled iPad to expose the battery (the LCD wasn’t cracked) I peeled the tape away at the bottom of the battery to expose the batter + and - terminals. I set my multimeter to DC and tested across the terminals. The reading was zero. I then plugged my charger in and tested whilst on charge and still zero.

So could be the charging chip??

完成的

添加一条评论

2个答案

已选择的解决方案

If the screen cracked after the drop, then it probably took some heavy damage internally. I presume you meant the front glass is cracked but it is also possible that the inner LCD is also damaged. As for the device not starting, it could also be caused by the battery connector becoming partially disconnected.

At any rate, the only way to understand the problem will be to open up the device and start troubleshooting. I would take a look at this guide to see if you are comfortable opening the device. The iPad mini is one of the more difficult iDevices to repair so you'll need to be honest with yourself about your abilities.

I would start by inspecting the LCD to see if it is cracked. If not, then check the battery and digitizer/lcd connections to insure they were properly seated. then you could measure the voltage directly at the battery. ~3V should be sufficient to allow the device to boot. So if the battery has more voltage than that, your problem may be within the logic board.

这个答案有帮助吗?

得分 2

10条评论:

Thanks for your answer. I will try what you suggest and post the results back

完成的

Good luck!

完成的

do i measure the voltage on the battery after its been charged for a few hours?

完成的

Sure, you can measure it before the charge and then after to see if it has an effect on the boot.

完成的

Update:

I dismantled iPad to expose the battery (the LCD wasn’t cracked) I peeled the tape away at the bottom of the battery to expose the batter + and - terminals. I set my multimeter to DC and tested across the terminals. The reading was zero. I then plugged my charger in and tested whilst on charge and still zero.

So could be the charging chip??

完成的

显示更多的5条评论

添加一条评论

Try to left it to charge for at least 2 hours.

then try to boot it in DFU mode, in itunes.

If nothing happens and stay undetected, then might have logic board issues

这个答案有帮助吗?

得分 0

2条评论:

Thanks for your help. Tried that but still nothing

完成的

then may have battery or logiboard issues....

完成的

添加一条评论

添加你的答案

ian 将永远感激不已
浏览统计数据:

过去 24 小时: 0

过去 7 天: 1

过去 30 天: 1

总计 146