After the washing machine runs through a full cycle working fine, on the very next load it starts in the agitation cycle. If the machine sits overnight it will work fine again, but on the next load it starts in the agitate cycle again. I replaced the timer part with a new one and it still does the same thing. Any ideas?
声誉积分: 689.2千
3.7千
1.1千
2.6千
This a a control board issue, I would first check the wiring connections. Sounds like something is heating up and disconnecting. If the wires are good (test with a multimeter before and after the problem to check for continuity) then go for he board. work it over with a soldering iron to repair a "cold solder" connection.
Here's how to do it: https://www.youtube.com/watch?v=h5_dBMuJ...
If all this fails, replace the high dollar board ;-(
这个答案有帮助吗？
过去 24 小时： 0
过去 7 天： 0
过去 30 天： 1
总计 248
