I am confused by step 18 (the last step). The directions say, "When reattaching the plastics to the glass, make sure the "#2" cable is routed as shown in the second picture." If you zoom on the middle picture it shows cable #2 underneath cable #3, as viewed from underneath. Yet #2 is on the outermost piece, which is the front panel. How is this possible?
声誉积分: 77.4千
361
106
146
as you put the digitiser in the midframe, slide the digitiser in speaker end first, so that cable goes beneath the midframe. if you turn digitiser over you'll see that the flex is actually about 1cm lower than the top of the screen, which is how it is able to fit through midframe.
这个答案有帮助吗？
+
过去 24 小时： 0
过去 7 天： 0
过去 30 天： 0
总计 438
